KOREASCHOLAR

This study is based on a representative body shape drawn from previous studies that classify adult male torso shapes. In this study, a design method is proposed by developing a tight-fit pattern that can be easily developed into various items and designs using the body surface development figure. This is obtained by converting the 3D body shape of the model representing the representative body shape. The specific design method was conducted as follows. Actual measurement values were used for waist back length, waist-to-hip length, shoulder length. The scye depth was determined as C/4–1.7 cm, and the front and back Interscye was set at (1/2 × actual measurements)–0.2 cm. The front-back neck breadth was set to (1/5 × base neck circumference)–1.3 cm and (1/5 × base neck circumference) cm. The front-back neck depth was set to (1/5 × base neck circumference)–1.2 cm and 3.5 cm. Front chest circumference was C/4–1 (front-back difference)cm; (1/4 × back chest circumference) was C/4 + 1 (front-back difference) + 0.3 (dart amount) cm. Front waist circumference was W/4–0.2 (front-back difference) + 2.2 (dart amount) cm; back waist circumference was W/4 + 0.2 (front-back difference) + 2.5 (dartamount) cm; front hip circumference was H/4 + 0.2 (ease) + 0.2 (front-back difference) cm; and back hip circumference was H/4 + 0.2 (ease)–0.2 (front-back difference) cm; Front droop was 1.6 cm. The newly developed tight-fit pattern is expected to be of great use as a basis for garment construction.

Abstract
I. Introduction
Ⅱ. Methods
    1. Selection of representative model of 3D bodyshape data
    2. Development figure of body surface
    3. Appearance evaluation by virtual garmentsimulation
    4. Data analysis
Ⅲ. Results and Discussion
    1. Making of body surface development figure
    2. Complete of tight-fit pattern for adult males’representative body shape
Ⅳ. Conclusion
References

• Eun-Hee Hong(한양대학교 의류학과) | 홍은희 Corresponding author