KOREASCHOLAR

The hydrogen embrittlement could lead to big damages in bolt/nut, fittings, especially, high pressure valve and high leak-proof valve and so on. Thus, special alloy, for instance, such as Monel and Inconel, is recently used to suppress the problems of hydrogen embrittlement in semiconductor facilities, FCEV(fuel cell electric vehicle) and hydrogen gas stations. The purpose of this study is to investigate the characteristics according to ratio change between drawing and extrusion of Monel material within elastic limit through numerical analysis. As the results, the possibility of plastic deformation in case of drawing was greater than that of extrusion. Consequently, the safety factor related to plastic deformation shows the results depending on the ratio change of force between drawing and extrusion.

Abstract
1. 서 론
2. 모 델링 및 수치해석 방법
3. 해석결과 및 고찰
4. 결 론
후 기
References

• 양영준(Professor, Future Automotive Eng., Gyeongsang National University) | Young-Joon Yang Corresponding author