논문 상세보기

디지털 엑스선 장비의 사지 검사 시 환자 체형에 따른 관전압 최적화 KCI 등재

Optimization of Tube Voltage according to Patient`s Body Type during Limb examination in Digital X-ray Equipment

  • 언어KOR
  • URLhttps://db.koreascholar.com/Article/Detail/336574
서비스가 종료되어 열람이 제한될 수 있습니다.
Journal of the Korean Society of Radiology (한국방사선학회논문지)
한국방사선학회 (The Korea Society of Radiology)
초록

본 논문은 디지털 엑스선 장비(DR)에서 사지 검사 시 환자 체형 변화에 따른 최적의 관전압을 알아보고 자 하였다. 상지검사는 면적선량(DAP) 5.06 dGy*cm², 하지검사는 DAP 5.04 dGy*cm² 고정한 상태에서 관전 압을 4단계 변화시키며 각 단계마다 3회씩 반복 촬영하였다. 환자의 체형의 변화를 주기 위해 10 mm 씩 총 30 mm까지 두께를 증가하였다. 정량적 평가를 위해 Image J를 이용하여 관전압에 따른 네 그룹간의 대 조도 및 신호 대 잡음비 값을 산출하였고 통계학적 검정은 95% 신뢰수준에서 Kruskal-Wallis test로 유의한 차이를 분석하였다. 영상의 정성적 분석을 위하여 정해진 항목에 관해 5점 리커트 척도로 평가 하였다. 상 지와 하지 실험 모두에서 관전압이 증가할수록 영상의 대조도대잡음비(CNR)과 신호대잡음비(SNR)이 감소 하였으며, 환자의 체형에 따른 차이를 보기 위한 실험에서는 두께가 두꺼워 질수록 CNR과 SNR이 감소하 였다. 정성적 평과는 상지는 관전압이 증가할수록 점수가 증가하여 최고 55 kV 에서 4.6, 40 kV 에서 3.6 이였으며, 하지는 관전압의 상관없이 평균 4.4의 고른 점수가 나왔다. 상, 하지 모두 두께가 두꺼워지면서 점수는 전반적으로 낮아졌으나 상지는 40 kV에서는 점수가 급격히 낮아졌고, 하지에서는 50 kV에서는 점 수가 급격히 낮아졌다. 표준 두께를 가지고 있는 환자의 경우 상지에서는 45 kV, 하지에서는 50 kV로 촬영 하는 것이 최적화 된 영상을 구현할 수 있으며, 환자의 체형 두께가 증가하는 경우 상지는 50 kV, 하지는 55 kV로 관전압을 설정 하는 것이 효과적이다.

This study identifies the optimal tube voltages depending on the changes in the patient’s body type for limb tests using a digital radiography (DR) system. For the upper-limp test, the dose area product (DAP) was fixed at 5.06 dGy*cm², and for the lower-limb test, the DAP was fixed at 5.04 dGy*cm². Afterwards, the tube voltage was changed to four different stages and the images were taken three times at each stage. The thickness of the limbs was increased by 10 mm to 30 mm to change in the patient’s body type. For a quantitative evaluation, Image J was used to calculate the contrast to noise ratio (CNR) and signal to noise ratio (SNR) among the four groups, according to the tube voltage. For statistical testing, the statistically significant differences were analyzed through the Kruskal-Wallis test at a 95% confidence level. For the qualitative analysis of the images, the pre-determined items were evaluated based on a 5-point Likert scale. In both upper-limb and lower-limb tests, the more the tube voltage increased, the more the CNR and SNR of the images decreased. The test on the changes depending on the patient’s body shape showed that the more the thickness increased, the more the CNR and SNR decreased. In the qualitative evaluation on the upper limbs, the more the tube voltage increased, the more score increased to 4.6 at the maximum of 55kV and 3.6 at 40kV, respectively. The mean score for the lower limbs was 4.4, regardless of the tube voltage. The more either the upper or lower limbs got thicker, the more the score generally decreased. The score of the upper limps sharply dropped at 40kV, whereas that of the lower limps sharply dropped at 50kV. For patients with a standard thickness, the optimized images can be obtained when taken at 45kV for the upper limbs, and at 50kV for the lower limbs. However, when the thickness of the patient’s limbs increases, it is best to set the tube voltage at 50 kV for the upper limbs and at 55 kV for the lower limbs.

목차
Ⅰ. INTRODUCTION
 Ⅱ. MATERIAL AND METHODS
  1. 대상 및 장비
  2. 실험방법
 Ⅲ. RESULT
 Ⅳ. DISCUSSION
 Ⅴ. CONCLUSION
 Reference
저자
  • 김상현(신한대학교 방사선학과) | Sang-Hyun Kim (Department of Radiological Science, Shinhan University)