논문 상세보기

EC-MBR 공정의 MLSS, 전류밀도 및 접촉시간이 막 오염 감소에 미치는 영향 모델링 KCI 등재

Modeling of the effect of current density and contact time on membrane fouling reduction in EC-MBR at different MLSS concentration

  • 언어KOR
  • URLhttps://db.koreascholar.com/Article/Detail/370675
구독 기관 인증 시 무료 이용이 가능합니다. 4,000원
상하수도학회지 (Journal of the Korean Society of Water and Wastewater)
대한상하수도학회 (Korean Society Of Water And Wastewater)
초록

Electro-coagulation process has been gained an attention recently because it could overcome the membrane fouling problems in MBR(Membrane bio-reactor). Effect of the key operational parameters in electro-coagulation, current density(ρ i) and contact time(t) on membrane fouling reduction was investigated in this study. A kinetic model for ρi and t required to reduce the membrane fouling was suggested under different MLSS(mixed liquor suspended solids) concentration. Total 48 batch type experiments of electro-coagulations under different sets of current densities(2.5, 6, 12 and 24 A/m2), contact times(0, 2, 6 and 12 hr) and MLSS concentration(4500, 6500 and 8500mg/L) were carried out. After each electro-coagulation under different conditions, a series of membrane filtration was performed to get information on how much of membrane fouling was reduced. The membrane fouling decreased as the ρi and t increased but as MLSS decreased. Total fouling resistances, Rt (=Rc+Rf) were calculated and compared to those of the controls (Ro), which were obtained from the experiments without electro-coagulation. A kinetic approach for the fouling reduction rate (Rt/Ro) was carried out and three equations under different MLSS concentration were suggested: i) pi0.39t = 3.5 (MLSS=4500 mg/L), ii) pi0.46t = 7.0 (MLSS=6500 mg/L), iii) pi0.74t = 10.5 (MLSS=8500 mg/L). These equations state that the product of ρi and t needed to reduce the fouling in certain amounts (in this study, 10% of fouling reduction) is always constant.

목차
ABSTRACT
 1. 서 론
 2. 재료 및 연구방법
  2.1 활성슬러지 배양
  2.2. 전기응집(Electro-coagulation)
  2.3 막 오염 정량화
 3. 결과 및 고찰
  3.1 전기응집 조건에 따른 여과 성능 비교
  3.2 활성슬러지 MLSS 농도에 따른 총오염저항 (Rt)의변화
  3.3 접촉시간 및 전류밀도에 따른 막 오염 저감 속도모델링
 4. 결 론
 References
저자
  • 김완규(호서대학교 안전환경기술융합학과) | Wan-Kyu Kim (Department of Convergence Technology for Safety and Environment, Hoseo University)
  • 장인성(호서대학교 환경공학과) | In-Soung Chang (Department of Environmental Engineering, Hoseo University) Corresponding author