검색결과

검색조건
좁혀보기
검색필터
결과 내 재검색

간행물

    분야

      발행연도

      -

        검색결과 126

        81.
        2003.06 구독 인증기관·개인회원 무료
        Using a developed high-frequency induction heated combustion method. the simultaneous synthesis and densification of WC-xvol.%Co() hard materials was accomplished using elemental powders of W, C and Co. A complete synthesis and densification of the materials was achieved in one step within a duration of 1min. The final relative densities of the composite were over 98.5% for all cases, under the applied pressure of 60 MPa and the induced current. The hardness of the composites decreases and the fracture toughness increases with increasing cobalt content. As the carbon to tungsten ration increases, the hardness increase, but the fracture toughness decreases. The maximum values for the fracture toughness and hardness are 15.1 (at 20vol.%Co, W:C=1:1), and 1928 (at 5vol.%Co, W:C=1:1.3), respectively. Therefore we concluded that the HFIHCS method. which can produce WC-xvol.%Co within 1 minute in one step is superior to conventional ones.
        82.
        2003.06 구독 인증기관·개인회원 무료
        1) Using a developed high-frequency induction heated sintering method, the rapid densification of WC-Co hard materials was accomplished using ultra fine powders with 260 nm size within 1 minute. 2) The relative density of the composite was 99.5% for the applide pressure of 60MPa and the induced current for 90% output of total capacity. 3) The grain size of WC-Co hard materials is about 260nm and the average thickness of the binder phase determined is about 11nm. The fracture toughness and the hardness of this work 12 , respectively. 4) Using pressureless sintering, we produced dense WC-Co hard materials with a relative density of 97% without applying pressure.
        87.
        2001.06 KCI 등재 SCOPUS 구독 인증기관 무료, 개인회원 유료
        Recently, we have set up a new digital CCD camera system, MicroMax YHS-1300 manufactured by Roper Scientific for Hα observation by Solar Flare Telescope at Bohyunsan Optical Astronomy Observatory. It has a 12 bit dynamic range, a pixel number of 1300×1030, a thermoelectric cooler, and an electric shutter. Its readout speed is about 3 frames per second and the dark current is about 0.05 e-/p/s at -10°. We have made a system performance test by confirming the system linearity, system gain, and system noise that its specification requires. We have also developed a data acquisition software which connects a digital camera con-troller to a PC and acquires Hα images via Microsoft Visual C++ 6.0 under Windows 98. Comparisons of high quality Hα images of AR 9169 and AR 9283 obtained from SOFT with the corresponding images from Learmonth Solar Observatory in Australia confirm that our Hα digital observational system is performed properly. Finally, we present a set of Hα images taken from a two ribbon flare occurred in AR 9283.
        4,000원
        95.
        1998.12 KCI 등재 SCOPUS 구독 인증기관 무료, 개인회원 유료
        We have observed the 10-9 transitions of HC3N and its 13C substitutes (H13CCCN,HC13CCN, and HCC13CN), and the vibration ally excited 12-11 (vr=1) HC3N transition toward the Sgr B2 molecular cloud. The observed HC3N emission shows an elongated shape around the Principal Cloud (~4.5 pc in R.A. × 7.4 pc in Decl.). The optically thin H13CCCN line peaks around the (N) core and we derive the total column density N(H13CCCN) = 4 ×10 13 cm-2 at this position. Toward the 2' N cloud which shows the peculiar chemistry, the HC3N lines show enhancements compared to the extended envelope. The shocks of the 2' N may have resulted in the enhancement of HC3N. The hot component of HC3N is strongly concentrated around the (N) core and its HPW is ~0.9 pc in diameter. We derive the lower limit of the abundance ratio N(HC3N)/N(H13CCCN) to be larger than 40 in most regions except the (M) and (N) cores. The fractionation processes of 13C at this region may not be as effective as previously reported.
        4,000원
        1 2 3 4 5