In this study, we reported the microstructure and properties of Ag- contact materials fabricated by a controlled milling process with subsequent consolidation. The milled powders were consolidated to bulk samples using a magnetic pulsed compaction process. The nano-scale phases were distributed homogeneously in the Ag matrix after the consolidation. The relative density and hardness of the Ag- contact materials were 95~96% and 89~131 Hv, respectively.

This article presents the successful consolidation of the mixed Co and Diamond powders for a drilling segment by the combined application of magnetic pulsed compaction (MPC) and subsequent sintering, and their properties were analyzed. Homogeneous hardness (Hv 220) and density (97%) of sintered bulks fabricated by MPC were obtained by the new technique, where higher pressure has been employed for short period of time than that of general process. A fine microstructure and homogeneous hardness in the consolidated bulk were observed without cracks. Relatively higher drilling speed of 9.61 cm/min and life time of 6.55 m were found to the MPCed specimens, whereas the value of the specimens fabricated by general process was 11.71 cm/min and 7.96 m, respectively. A substantial improvement of mechanical properties of segment was achieved through this study.

The effects of the dopant (Mn) ratio on the microstructure and thermoelectric properties of alloy were studied in this research. The alloy was fabricated by a combination process of ball milling and high pressure pressing. Structural behavior of the sintered bulks were systematically investigated by XRD, SEM, and optical microscopy. With increasing dopan (Mn) ratio, the density and phase of the sintered bulks increased and maximum density of 94% was obtained in the 0.07% Mn-doped alloy. The sintered bulks showed fine microstructure of , and phase. The semiconducting phase of was transformed from phase by annealing

Environment friendly agricultural material products (EFAMs) in current market were evaluated for their insecticidal or acaricidal activities. EFAMs were evaluated against Tetranychus urticae, Plutella xylostella, Myzus persicae and Nilaparvata lugens in spray method. Several EFAMs indicated high control value in spray method. Hatchability of T. urticae was relatively high after EFAM treatment. some materials show high insecticidal activities against P. xylostella larvae but not against eggs. Few meterials showed more than 80% insecticidal activities against M. persicae and N. lugen. The control value of more than half the materials for pest control was lower than 60%. EFAMs containing S. flavescens, neem oil and Rape showed higher control value