The synthetic behaviors of carbon nanotubes (CNTs) by Fe/MgO catalysts were investigated in 0~90 wt.% range of MgO mixture ratios by catalytic chemical vapor deposition (CCVD) process. The CNTs were synthesized with 40 minutes of synthetic time, and 923 K of synthetic temperature using 0.1 L/min of ethylene gas and 1.0 L/min of hydrogen gas as synthetic and carrier gas, respectively. As the increase of synthetic temperatures and times, the diameters of CNTs become thicker. The carbon yield showed in a parabolic curve as MgO content increased and the maximum carbon yield was obtained at 30 wt.% of MgO. There were no obvious changes in the diameters of CNTs respect to the change of MgO content. Fe/MgO CNTs showed good crystalinity by High Resolution Transmission Electron microscope (HR-TEM) analysis. The behaviors of Fe/MgO CNTs have a tendency of depending on synthetic time and temperature rather than MgO content.

Mucin coat is deposited on the embryos during passage through the oviduct in rabbit. When in vitro cultured blastocysts were transferred to the recipients, the lack of mucin coat might account in part for failure of pregnancy after transfer. The present study were carried out to investigate whether deposition of mucin coat were induced when in vitro cultured blastocysts were transferred to recipients. At 19 ～20 hours post-coitus one-cell embryos were collected by flushing oviducts. These embryos cultured for 72 hours were reached to blastocyst stage. And these blastocysts were transferred to the oviduct of asynchronized (one day later than the donors) and synchronized recipient. To confirm deposition of the mucin coat, blastocysts transferred to the oviduct were recovered at 24 and 48 hours after the transfer. Fifty eight percent of blastocysts recovered from uterus of asynchronous recipient at 24 hours after transfer and 92.9% of blastocysts recovered from uterus of synchronous recipient were 0～10 ㎛ of mucin coat thickness. And 11.8% of blastocysts of asynchronized recipients and 7.1% of blastocysts from asynchronized recipients were in 11～20 ㎛ of mucin coat thickness. When blastocysts were recovered from uterus at 48 hours after transfer, 87.0% of blastocysts from asynchronized recipients and 5.9% of blastocyst from synchronized recipients were in 0～10 ㎛ of mucin coat thickness. And 76.5% of blastocysts of synchronized recipients and 4.4% of blastocysts from asynchronized recipients were in 11～20 ㎛ of mucin coat thickness. From these results it is speculated that the low implantation rate of in vitro cultured rabbit blastocysts transferred to oviduct of recipient was caused by high degeneration of the embryo after transfer and inappropriate deposition of mucin coat.

The effect of compositions of Al2O3 in the mixed Fe/Al2O3 catalysts on the synthetic behaviors of carbon nanotubes (CNTs) by catalytic chemical vapor deposition (CCVD) process was investigated in wide range of the mixture ratios of support materials. CNTs were synthesized with Fe/Al2O3 catalysis under the condition of 40 min in synthetic time, and 923 K of synthetic temperature using C2H4 and H2 as synthetic and carrier gas, respectively. The carbon yield with the content of Al2O3 showed in a parabolic curve and the maximum carbon yield was 40 wt.% of Al2O3. As the mixture ratio of Al2O3 increased, decreasing tendency was observed in the diameter of CNTs. Specific surface areas of CNTs were increased with the increase of the mixture ratio of Al2O3.

Ni coated composite was successfully Prepared by the electroless deposition Process. The average size of Ni particles coated on the matrix powder was about 20 nm. It was hard to find any reaction compound as an impurity at interface between and Ni particles after sintering. The characterization of microstructure crystal structure and fracture behavior of the sintered body were investigated using XRD, TEM and Victors hardness tester, and compared with those of the sintered monolithic body. Many dislocations were observed in the Ni phase due to the difference of thermal expansion coefficient between and Ni phase, and no observed microcracks at their and Ni interface. In the /Ni composite, the main fracture mode showed a mixed fracture with intergranular and transgranuluar type having some ,surface roughness. The fracture toughness was slightly increased due to the plastic deformation mechanism of Ni phase in the /Ni composite.

Hydroxyapatite(HA) has been widely used as bone substitutes to rehabilitate bone loss area by new bone formation. But there were some problem of bone formation around HAs due to a little space between HAs embedded in bone loss area. The purpose of this study was to observe morphologically new bone formation around HAs mixed with PLGA block (5.5㎜ in diameter, 4 mm in depth) in Newzealand white rabbit tibia. Before 1 week of sacrification, Alizarin red was injected intraperitoneally into rabbit. At 3 day, 1, 2, 4, 10, 18, 32 weeks, bones with HA as control group(CG)and HA mixed with PLGA block as experimental group (EG)were fixed with 10 % neutral formalin, dehydrated, and embedded with Spurr low viscosity resin. After the specimens were cut by 500 ㎛ with slow diamond wheel saw, these were coated with carbon and examined by REM, LSM and qualifative analysis of calcium and phosphorous deposition were done with EPMA. The obtained results were as follows. 1. Both group showed scattered HA around compact bone under REM and little AZ labelled bone under LSM at 3 days. 2. Both group showed active AZ labelled bone, while EG showed higher Ca(calcium) and P(phosphate) deposition than that of CG at 1 wk. 3. There was decreased AZ labelled bone of both group under LSM. REM of EG showed HA associated with new bone from compact bone, while EPMA features showed similar to Ca and P deposition at 1 wk and EG showed higher than that of CG. 4. REM features of both group showed resorbed HA associated with new bone. There was decreased AZ labelled bone of both group under LSM. EPMA features showed higher Ca and P deposition at 4 wks than that of 2 wks. 5. New bone of both group was well demarcated from compact bone under REM at 10 wks. LSM features showed various AZ labelled bone, but weak AZ labelled than that of CG. 6. LSM features of 14 wks showed discontinuous AZ labelled on osteon formation. EPMA of both group showed increased Ca deposition, while there was higher Ca deposition of EG and similar P deposition to CG. 7. REM featureless of 18 wks in EG showed similar gray color to compact bone. LSM features showed osteon formation with little concentric lamellars. EPMA of both group showed increased Ca deposition, while there was higher Ca and P deposition of EG. 8. New bone was ill demarcated from compact bone and increased otseon formation of REM features at 32 wks. There was little AZ labelled bone. EPMA features showed higher Ca and P deposition of EG than that of compact bone. From the aboving results, there was early active AZ labelled bone of both group within 1-2 weeks and since 18 weeks new bone with active osteon formation was poorly demarcated from compact bone. Calcium deposition of EG was early increased than that of CG deposition since 4 weeks after experiments. It was suggested that EG showed active and rapid new bone formation and similar bone mineralization of compact bone