This study sought to conduct a fundamental investigation in order to test and evaluate the thermal performance of an aluminum stick curtain wall system. In terms of the thermal performance index, the infiltration rate of air tightness, thermal transmittance of the heat insulation property and temperature difference ratio of condensation resistance were experimentally measured. The research process can be divided into three parts. First of all, a database for the test report of the curtain wall was compiled and existing design criteria with respect to the evaluation method and standard of transparent building components such as curtain wall, window and door were analyzed to produce the specimens. Secondly, four different types of curtain wall specimens were created through investigating the curtain wall database. Thirdly, standard tests of thermal performance were carried out for airtightness, thermal performance and condensation resistance. As a result, the curtain wall specimens with low-e triple glazing covered by an aluminum capture system showed high thermal performance compared to other curtain wall specimens including low-e triple glazing with a 4-sided structural sealant glazing system. Air tightness of all types of curtain wall specimens satisfied level 1 standard for air tightness. It was found that a curtain wall which consists of a one track frame has difficulties meeting the residential standard of thermal performance with regard to thermal transmittance and condensation resistance.

The office building more than 3,000㎡ of the total floor area should be needed to improve the energy efficiency based on government's recommendation. In this study, the new composite panel with structural function is conducted to check the thermal conductivity for application of exterior wall. The thermal transmittance was calculated by dynamic analysis to consider the thickness of insulation only per locations based on design criteria. The simulation program for the analysis was used TRISCO Radcon module, which has a function of a steady-state 3-dimensional heat transfer analysis.

In this study, thermal performance test of VMD module was performed, prior to the construction of the demonstration plant using the vacuum membrane distillation　(VMD) module of the capacity of 400 m3/day and to the commercialization of the VMD module. For the thermal performance test, the experimental equipment of capacity of 2 m3/day was constructed. The permeate flux test and thermal performance test according to feed water conditions such as temperature and flow rate were conducted. The VMD module used in the study was manufactured by ECONITY Co., LTD with PVDF hollow fiber membrane. As a result, the Performance Ratio (PR) of the VMD module showed the maximum value of 0.904 under the condition of feed water temperature of 75℃ and flow rate of 8 m3/h. PR value of the VMD module using PVDF hollow fiber membrane showed linearly increasing relationship with feed water temperature and flow rate. Also, The permeate flux of the VMD module was analyzed to have maximum value of 18.25 LMH and the salt rejection was 99.99%.

Heat transfer enhancement of fin-tube heat exchangers with vortex generators is investigated using naphthalene sublimation technique. Experiments are performed for the fin-flat tube and the fin-circular tube heat exchangers with and without vortex generator. Vortex generators are found to enhance heat transfer rate on the fin surface dramatically. Their effect is relatively high in the fin-flat tube heat exchanger compared to fin-circular tube heat exchanger. Performance test is done for the prototype of air-conditioning heat exchanger and gas boiler heat exchanger with and without vortex generators .Fin-flat tube heat exchanger with vortex generator promote local heat transfer coefficient by 75% and increase friction factor, but friction of fin-flat tube heat exchanger with vortex generator is lower than that of fin-circular tube heat exchanger without vortex generator by 45%