Silver particles were synthesized from silver nitrate by homogeneous precipitation and chemical reduction methods involving the intermediate silver cyanate. The obtained silver particles were characterized by XRD, SEM, TEM, and BET. Urea which could prevent the agglomeration of the reduced silver particles was used as a homogeneous precipitator. The spherical silver particles with average particle diameter of 100 nm were obtained under the optimum reaction conditions. The optimum synthetic conditions were found as follows: reaction temperature , reaction time 60 min, concentration of silver nitrate mol, urea mol, and sodium citrate mol. The phase of obtained silver particles was crystalline state and the silver particles were relatively dense, which had the surface area of .

Multi-walled carbon nanotube (MWNT)/SnO2 nano-composite (MSC) for the anode electrode of a Li-ion battery was prepared using a homogeneous precipitation method with SnCl2 precursors in the presence of MWNT. XRD results indicate that when annealed in Ar at 400˚C, Sn6O4(OH)4 was fully converted to SnO2 phases. TEM observations showed that most of the SnO2 nanoparticles were deposited directly on the outside surface of the MWNT. The electrochemical performance of the MSC electrode showed higher specific capacities than a MWNT and better cycleability than a nano-SnO2 electrode. The electrochemical performance of the MSC electrode improved because the MWNT in the MSC electrode absorbed the mechanical stress induced from a volume change during alloying and de-alloying reactions with lithium, leading to an increase in the electrical conductivity of the composite material.

Dispersion stabilities and photocatalytic activities of rutile powders with unique nano-structure synthesized by homogeneous precipitation process at low temperature(HPPLT) have been investigated in the acrylic resin containing fluorostyrene in the range of mole. Isoelectric point of in the acrylic resin placed in the neutral region whereas that of in the water placed in the acidic region, indicating that zeta potential and agglomeration of powder is strongly dependent on the pH and the type of solvent. To prepare an adhesion, an acrylic resin containing fluorostyrene was synthesized by a radical polymerization. The adhesion of coating layer was increased with increasing fluorostyrene's contents without changing the dispersion stabilities and degrading photocatalytic properties

YIG 전구체 분말은 요소의 열분해반응을 이용한 균일침전법에 의해서 질산염으로부터 제조하였다. 침전은 철이온이 먼저 침전한 후 이트륨이온이 침전하는 과정으로 이루어졌다. YGI전구체 분말은 철산화물과 비정질로 구성되어 있으며 그 분말의 대략적인 화학식은 2.5Fe2O3.Y3(OH)9-2x(CO3)x.nH2O로 되어있다. YIG 전구체 분말의 열분해과정은 dehydration, 철산화물의 recrystallization, yttrium carbonate 및 yttrium oxide의 형성과 고상반응등 여러단계로 구성되어 있다. 열처리온도가 증가함에 따라 Y2O3와 Fe2O3의 고상반응에 의해 YFeO3 intermediate을 경유해서 YIG상이 형성됨을 확인하였다. 단일상의 YIG는 1200˚C에서 6시간 공기중에서 소성함에 의해서 얻을 수 있었다.