Browning technology for shiitake in sawdust using LED source
- 언어ENG
- URLhttps://db.koreascholar.com/Article/Detail/365074
pp.331-333
The incorporation of Shiitake culture into sawdust is a widely utilized technique that can assist in reducing the cost and time consumption associated with oak cultivation. In sawdust cultivation, browning of the surface mycelia is an important stage with respect to the utility and longevity of the sawdust media. Surface browning forms a protective coating on the substrate, which can inhibit the invasion of pathogens and suppress water evaporation. Several different light sources (red LED, white LED, blue LED, and fluorescent light) were used and the intensity of illumination was carefully controlled (1.5, 10.5, 20.5 μmol/m2s for LEDs and 10, 100, 300 lux for the fluorescent light) to induce browning. The light sources were regulated via a 1 h on/off cycle in a controlled room environment at a temperature of 20°C, 60% humidity, and 1200 ppm CO2 concentration for 60days.The browning effect varied depending on the source and the intensity of illumination. This effect was most effectively induced at 1.5 μmol/m2s for the red and blue LEDs. All light sources induced less browning at the highest intensity of illumination. This indicates that intensity values higher than 20.5 μmol/m2s in the case of the LEDs and 300 lux for the fluorescent light are not effective. After harvesting of the fruit bodies, we measured the weight, length, and width of the pileus and stipe in addition to their chromaticity and hardness. Treatment with 1.5 μmol/m2s blue LED produced the best harvest with the highest average chromaticity, weight (21.2 g), stipe length (30.8 mm), and hardness (377.9 g), with a fine length and width of the pileus.
Browning Effects of Medium by Source and Intensity of Light
The Difference in Growth by Source and Intensity of Light
REFERENCES