The present work reports a systematic study of using carboxymethylated cellulose (CMC) as water-bornebinder to produce Li4Ti5O12-based anodes for manufacture of high rate performance lithium ion batteries. When theLTO-to-CB-to-CMC mass ratio is carefully optimized to be 8:1:0.57, the special capacity of the resulting electrodes is144 mAh·g−1 at 10 C and their capacity retention was 97.7% after 1000 cycles at 1C and 98.5% after 500 cycles at5C, respectively. This rate performance is comparable or even better than that of the electrolytes produced using con-ventional, organic, polyvinylidene fluoride binder.

1. Introduction
 2. Experimental Section
  2.1. Synthesis of LTO particles
  2.2. Material characterization
 3. Results and Discussion
 4. Conclusions
 Acknowledgements
 Reference

• Lili Liu(Department of Chemistry, College of Science, Shanghai University, Shanghai 200444, P.R. China)
• Chongling Cheng(School of Civil, Environmental, and Chemical Engineering, RMIT University, VIC 3001, Australia)
• Hongjiang Liu(Department of Chemistry, College of Science, Shanghai University, Shanghai 200444, P.R. China) Corresponding Author
• Liyi Shi(Department of Chemistry, College of Science, Shanghai University, Shanghai 200444, P.R. China) Corresponding Author
• Dayang Wang(School of Civil, Environmental, and Chemical Engineering, RMIT University, VIC 3001, Australia)