논문 상세보기

Analysis of in-situ bond strength of bonded concrete overlay

  • 언어ENG
  • URLhttps://db.koreascholar.com/Article/Detail/319043
모든 회원에게 무료로 제공됩니다.
한국도로학회 (Korean Society of Road Engineers)
초록

More than sixty percent of highways in Korea were constructed with concrete pavement to carry the heavy traffic loads due to the economic development of this country. The service life of some pavements are close to the end, therefore, they requires the maintenances, rehabilitations and reconstructions to improve their structural performances.According to the similarity of material properties to the concrete pavement, bonded concrete overlay isa good rehabilitation technique used steadily in Korea. However, it is recently reported that the bonded concrete overlays in some highways expose the early distresses and it is assumed that the poor bonding is a cause of this problem. Additionally, the poor bonding of bonded concrete overlay is caused by the bond strength that is less than the bond strength criterion. The pre-investigation of various concrete overlays is conducted in laboratory to determine the possible influence factors reducing the bond strength and it indicates that there are two possible factors affecting the bond strength: the concrete overlay types and the substrate conditions. The study investigates the vulnerable factor between the two factors based on theevaluation of the in-situ bond strength data of bonded concrete overlay gathered from some highways in Korea. The bond strength data is collected from two different application areas: the new constructionand the rehabilitation projects. The new construction and the rehabilitation projects used Latex-modified Concrete (LMC) and Ultra-rapid Hardening Latex-modified concrete (URH-LMC), respectively as the concrete overlay. The evaluation of in-situ bond strength is to determine the percentage of unacceptable bond strength in each projectto study the effect of different types of concrete overlay. Moreover, the percentage of bonding failure modes having the bond strengths less than the criterion is also measured to study the effect of substrate condition.As a result, substrate condition is the vulnerable factor affecting the poor bonding and causing the early distresses in bonded concrete overlay.

저자
  • Rith Makara(Gangneung-Wonju National University. Graduate Student)
  • Kim Young Kyu(Gangneung-Wonju National University. PhD)
  • Lee, Seung Woo(Gangneung-Wonju National University. Professor(PhD))
  • Park Jun Young(Korea Expressway and Transportation Research Institute. Senior Researcher of Pavement Research Division)
  • Han Seung Hwan(Korea Expressway and Transportation Research Institute. Chief of Pavement Research Division)