Evaluation of Moldability and Mechanical Properties of Long Fiber-Reinforced Thermoplastic Composites under Injection Molding Conditions
본 연구에서는 FRP 패스너 형상부 제작을 위한 기초 연구로서, 다양한 사출성형 조건에 따른 장섬유강화 열가소성 복합재 (Long Fiber-Reinforced Thermoplastic, LFT)의 성형성 및 기계적 특성을 평가하였다. 사용된 LFT 복합재는 PA6 매트릭스에 탄소 섬유가 함침된 재료이며, 몰드온도, 사출온도 및 사출압력을 주요 공정 변수로 선정하였다. 성형성은 시편의 중량과 직경을 측정하여 평가하였으며, 기계적 특성과 파단 거동은 인장시험 및 SEM 관찰을 통해 분석하였다. 실험 결과, 사출압력이 증가함에 따라 시편의 중량은 전반적으로 증가하였으며, 이는 금형 내 충전성이 향상되었음을 의미한다. 몰드온도 100°C 조건에서는 치수 편차가 감소하여 치수 균일성이 향상된 것으로 나타났다. 또한 사출압력 증가에 따른 인장강도 및 탄성계수의 감소율은 60°C 조건보다 100°C 조건에서 더 낮게 나타났다. SEM 관찰 결과, 과도한 사출온도와 사출압력은 섬유 pull-out, 계면 박리 및 공극 형성을 촉진하는 것으로 확인되 었다. 본 연구 범위에서는 몰드온도 100°C 조건이 성형성과 기계적 특성 확보에 적절한 것으로 판단된다.
This study evaluated the moldability and mechanical properties of long fiber–reinforced thermoplastic (LFT) composites under various injection molding conditions as a fundamental investigation into the manufacturing of shaped components for fiber-reinforced polymer fasteners. The LFT composite used in this study consisted of carbon fibers impregnated in a PA6 matrix, and mold temperature, injection temperature, and injection pressure were selected as the main variables for process optimization. Moldability of LFT composites was evaluated by measuring the weight and diameter of the specimens, while their mechanical properties and fracture behavior were analyzed through tensile testing and scanning electron microscopy (SEM) observation. The experimental results showed that specimen weight generally increased with increasing injection pressure, indicating improved mold filling. At a mold temperature of 100°C, dimensional variations in the specimens decreased, indicating improved dimensional uniformity. In addition, the reductions in tensile strength and elastic modulus of the specimens with increasing injection pressure were smaller at 100°C than those at 60°C. SEM observations confirmed that excessively high injection temperature and injection pressure promoted fiber pull-out, interfacial debonding, and void formation within the specimens. Within the scope of this study, the mold temperature condition of 100°C was considered advantageous for achieving a balance between moldability and mechanical properties..