Fe-TiC composite was fabricated from Fe and TiC powders by high-energy milling and subsequent spark- plasma sintering. The microstructure, particle size and phase of Fe-TiC composite powders were investigated by field emission scanning electron microscopy and X-ray diffraction to evaluate the effect of milling conditions on the size and distribution of TiC particles in Fe matrix. TiC particle size decreased with milling time. The average TiC particle size of 38 nm was obtained after 60 minutes of milling at 1000 rpm. Prepared Fe-TiC powder mixture was densified by spark- plasma sintering. Sintered Fe-TiC compacts showed a relative density of 91.7~96.2%. The average TiC particle size of 150 nm was observed from the FE-SEM image. The microstructure, densification behavior, Vickers hardness, and frac- ture toughness of Fe-TiC sintered compact were investigated.

We present a multi-dimensional reduction method of the surveyed cube database obtained using a single- dish radio telescope in Taeduk Radio Astronomy Observatory (TRAO). The multibeam receiver system installed at the 14 m telescope in TRAO was not optimized at the initial stage, though it became more stabilized in the following season. We conducted a Galactic Plane survey using the multibeam receiver system. We show that the noise level of the first part of the survey was higher than expected, and a special reduction process seemed to be definitely required. Along with a brief review of classical methods, a multi-dimensional method of reduction is introduced; It is found that the ‘background’ task within IRAF (Image Reduction and Analysis Facility) can be applied to all three directions of the cube database. Various statistics of reduction results is tested using several IRAF tasks. The rms value of raw survey data is 0.241 K, and after primitive baseline subtraction and elimination of bad channel sections, the rms value turned out to be 0.210 K. After the one-dimensional reduction using ‘background’ task, the rms value is estimated to be 0.176 K. The average rms of the final reduced image is 0.137 K. Thus, the image quality is found to be improved about 43% using the new reduction method.

As a specialty oil, furan fatty acids have gained special attentions since they are known to play important roles in biological systems including human. Although several studies reported chemical synthesis of furan fatty acids, their synthesis consisted of complicated chemical multistep with chemical catalysts. Recently, a simple one-step heat treatment method was developed to produce a novel furan fatty acid, 7,10-epoxy-octadeca-7,9-dienoic acid (7,10-EODA) from a dihydroxyl fatty acid 7,10-dihydroxy-8(E)-octadecenoic acid (DOD). In this report we studied about optimization of environmental conditions for the maximum production of 7,10-EODA from DOD by heat treatment. Production of 7,10-EODA was maximized at over 85℃ for at least over 48 hour in hexane. Solvent volume for maximum production should be over 300 mL per 10 mg DOD.