검색결과

검색조건
좁혀보기
검색필터
결과 내 재검색

간행물

    분야

      발행연도

      -

        검색결과 2

        1.
        2021.02 KCI 등재 구독 인증기관 무료, 개인회원 유료
        Bulk graphite is manufactured using graphite scrap as the filler and phenolic resin as the binder. Graphite scrap, which is the by-product of processing the final graphite product, is pulverized and sieved by particle size. The relationship between the density and porosity is analyzed by measuring the mechanical properties of bulk graphite. The filler materials are sieved into mean particle sizes of 10.62, 23.38, 54.09, 84.29, and 126.64 μm. The bulk graphite density using the filler powder with a particle size of 54.09 μm is 1.38 g/cm3, which is the highest value in this study. The compressive strength tends to increase as the bulk graphite density increases. The highest compressive strength of 43.14 MPa is achieved with the 54.09 μm powder. The highest flexural strength of 23.08 MPa is achieved using the 10.62 μm powder, having the smallest average particle size. The compressive strength is affected by the density of bulk graphite, and the flexural strength is affected by the filler particle size of bulk graphite.
        4,000원
        2.
        2019.12 KCI 등재 구독 인증기관 무료, 개인회원 유료
        The present study examined changes in surface shape and pore size observed in carbon black particles isothermally oxidized in an air atmosphere according to their burn-off ratio. Carbon black materials were fed into a horizontal tubular furnace in an air atmosphere when the inside temperature reached 600 °C. Subsequently, while changing the isothermal oxidation time, carbon black samples with different burn-off ratios were obtained, i.e., 10.5, 20.0, 30.4, 41.0, 49.9, 59.8, 71.1, and 81.0%. The scanning electron microscope analysis revealed that the observed carbon black particles were in the form of aggregated primary particles, and that there was no change in the particle size of these primary particles as the burn-off process proceeded. The latter observation supported the observation that pores were formed in the carbon black samples during the burn-off process. Notably, the Brunauer–Emmett–Teller analysis exhibited hysteresis curves, indicating that the corresponding adsorption isotherms were of IV-type. It was also found that the area of the hysteresis curves increased as the burn-off process proceeded. The specific surface area of the raw carbon black sample was 58.00 m2/g, while that of the 81.0% sample was about 4.1 times the figure at 240.27 m2/g. The total pore volume VT was 0.17 cm3/g for the raw sample, and it was much higher for the 81.0% sample at 0.58 cm3/g. The transmission electron microscope analysis showed that the raw carbon black particles had a spherical shape with a smooth surface, but inner pores were not observed. In the 49.9% sample, pores with a size of about 5 nm were observed inside carbon black particles. Notably, the size of the pores observed in the 81.0% sample was about 20 nm and the large pores were created by the collapsing and merging of the smaller pores by oxidation.
        4,200원