The optimal determination of seeding rate is critical to minimizing uncertainties about the large variations observed in forage quality and productivity when alfalfa is cultivated under different geographical areas and growing conditions. The objective of this investigation was to provide information about the proper seeding rate according to harvest timing for alfalfa cultivation in the Northern regions of Korea. Alfalfa was sown in September 2018 at a seeding rate of 20, 30 or 40 kg/ha and harvested four times in 2019: May 3, July 2, September 11, and October 13. Regardless of seeding rate, alfalfa plant height was longest at the third harvest (113 cm) and the shortest in the last annual harvest (43.8 cm). However, seeding rate had no effect on alfalfa plant height at any harvest. Forage relative feed value was increased in the first cutting but decreased in the third cuttings as seeding rate increased. However, seeding rate had slight effect on alfalfa forage quality components at the second and fourth cuttings. Total annual DM and crude protein production (in 4 harvests) was greater at higher seeding rates. Plots seeded at a rate of 40 kg/ha produced on average 1,257 and 2,620 kg/ha more forage (DM basis) than those seeded at a rate of 30 or 20 kg/ha, respectively. Forage DM production at the first, second, third, and fourth harvests accounted for 36.1, 24.0, 27.1, and 12.8 % of total annual DM production, respectively. Overall, small differences were seen when alfalfa seeding rate was different but maximum forage DM production (in four harvests) was detected when seeding rate was 40 kg/ha. These data could be useful to the alfalfa growers by allowing them to make more accurate trade-offs between seed price and the expected magnitude of forage yield gains in order to select the best seeding rate.

Cutting management has been identified as a critical factor in the alfalfa production systems because it has a significant impact on maximizing yield and maintaining the forage quality. The objective of this experiment was to determine the proper cutting height according to harvesting time for optimizing nutrient yield and forage nutritive quality of alfalfa grown in alpine regions of Korea. Alfalfa was sown at a seeding rate of 30 kg/ha in August 2018 and harvested at four cuttings in 2019 (3 May, 2 July, 11 September, and 13 October). Cutting heights were adjusted at 5, 15, and 25 cm above the soil surface. Alfalfa plant was tallest at the third cutting (109 cm), which was on average 35 cm taller than the first or second cutting. Relative feed value (RFV) remained unaffected by cutting height at the first harvest, but increased consistently in subsequent harvests as cutting height increased. Alfalfa collected at the first and fourth cuttings had the highest RFV (mean 152), which was on average 8 and 67 units higher than the second and third harvests, respectively. At each harvest, in vitro dry matter digestibility was highest in alfalfa cut at a 25-cm height. Dry matter (DM) production at each cutting height was highest in the first cutting, accounting for on average 36-37% of total annual DM production, and lowest in the fourth harvest, accounting for about 11-13% of the total DM yield. The total dry matter production (in four harvests) was 4,218 kg/ha higher when alfalfa was subjected to a cutting height of 5 cm rather than 25 cm. Cutting height had no effect on total crude protein yield, but from the first to fourth cutting, the protein yield followed a decreasing trend. Finally, there were visible declines in forage nutritive quality when alfalfa was cut at a shorter height. However, the magnitude of difference in total forage yield may outweigh the slight decline in forage quality when alfalfa is cut at a lower height. The findings of this study could help the alfalfa growers make better harvest management decisions.