현재 기후변화 문제 해결을 위한 국제적 목표 및 국내 에너지 정책에 부합하는 LNG 발전의 효율성을 극대화하는 방안이 요구 되고 있다. 2050년 탄소중립 목표 달성을 위해 각국은 2030년까지 온실가스 감축 목표를 설정하였고, 국내에서도 석탄 발전 시설을 단계 적으로 폐쇄하고 LNG 발전 시설을 확대하려는 노력이 진행되고 있다. 이 연구에서는 LNG의 재기화 과정에서 발생하는 냉열을 회수하여 Carbon Capture and Storage, Ammonia-water Rankine Cycle / Kalina Cycle, Data Center Cooling, Direct Expansion 공정에 활용할 수 있는 시스템을 제안하였다. 연구 결과 제안된 시스템의 3E 분석 결과 Energy 효율 51.52%, Exergy 효율 42.74%, 환경적 측면에서 2,145.8 gCO2 / kgLNG의 탄 소 배출량을 보여 가장 우수한 성능을 확인하였다. 이를통해 본 연구에서 새롭게 제시한 시스템은 Energy, Exergy, 환경성 측면에서 강점을 가지며, 향후 기후변화 대응에 크게 기여할 것으로 판단된다.

In the modern industrial period, the introduction of mass production was most important progress in civilization. Die-casting process is one of main methods for mass production in the modern industry. The aluminum die-casting in the mold filling process is very complicated where flow momentum is the high velocity of the liquid metal. Actually, it is almost impossible in complex parts exactly to figure the mold filling performance out with the experimental knowledge. The aluminum die-castings are important processes in the automotive industry to produce the lightweight automobile bodies. Due to this condition, the simulation is going to be more critical role in the design procedure. Simulation can give the best solution of a casting system and also enhance the casting quality. The cost and time savings of the casting layout design are the most advantage of Computer Aided Engineering (CAE).. Generally, the relations of casting conditions such as injection system, gate system, and cooling system should be considered when designing the casting layout. Due to the various relative matters of the above conditions, product defects such as defect extent and location are significantly difference. In this research by using the simulation software (AnyCasting), CAE simulation was conducted with three layout designs to find out the best alternative for the casting layout design of an automotive Oil Pan_BJ3E. In order to apply the simulation results into the production die-casting mold, they were analyzed and compared carefully. Internal porosities which are caused by air entrapments during the filling process were predicted and also the results of three models were compared with the modifications of the gate system and overflows. Internal porosities which are occurred during the solidification process are predicted with the solidification analysis. And also the results of the modified gate system are compared.