PURPOSES: Design of approach roads of rest areas in highway has many drawbacks such as geometric design elements. There has been traffic accidents occured in these approach roads of rest areas. Thus, design criteria is required in order to protect accidents from being occurred. In case of Korea, geometric structure design criteria of entry facilities, such as toll-gate, interchange, junction etc was established. However there are no presence in a detailed standards for geometric structure of the rest area which affiliated road facilities. METHODS: In this study, analytic on accidents was carried out in regards to the entry of geometric structure of resting areas by utilizing a sight survey and an investigation research of traffic accidents. The survey was targeting 135 general service areas. Collisions with physical channelization and safety facilities occurred due to speeding, rapid entry, and etc at the entrance nose section. At the entrance connector roads, accidents caused by speeding, negligence, over-operation of handle of drivers were main reason of accidents. Discriminant analysis were conducted about geometric elements to distinguish influencing factors for traffic accidents. the lengths and access angles of the entrance connector roads were regarded as to have the high relation with traffic accidents. RESULTS: After classifying the design section of resting areas' entry as well as derive design elements on each section, a speed measurement by targeting entry of rest areas and car behavior surveys were performed, then each element's minimum standard was derived through the analyses. According to the speeds at the starting/end point of entrance connector road, the range of the junction setting angle of the entrance connector road is defined as 12˚~17˚ and the connector length model was suggested. CONCLUSIONS: Suggest improvement plans for existing rest areas that can be applied realistically. This should be corresponded to the standards of entry and exit of developed rest areas.
최근 비점오염원에 대한 관심이 높아지면서, 환경부 및 유관단체를 중심으로 노면 유출수를 포함한 비점오염원(Non point source)에 대한 현황 조사 및 처리 방법에 대한 관심이 증가하고 있다. 고속도로 휴게소 주차장 노면 유출수는 고속도로 본선 노면 유출수보다 유해물질 오염도가 높을 것으로 예상되어, 본 연구는 이 지역의 노면 유출수 오염도 조사를 통해 유출수 평가 및 노면 유출수 저감시설의 저감효과를 분석하여 휴게소 노면유출수 관리방안을 수립하는 것을 목적으로 하고 있다. 휴게소지점에 대한 강우 유출수 분석 결과 포장지역의 특성인 초기강우현상을 볼 수 있었으며, 강우초기에 입자상물질은 중금속과 결합하여 다량 유출되는 특성을 나타내었다. 휴게소 지점의 강우유출수에 대한 오염물질별 EMC에 대한 95% 확신범위로는 TSS 128.2-273.4mg/L, COD 145.4-310.1mg/L, TN 6.1-11mg/L, TP 1.9-2.9mg/L의 범위로 분석되어 고속도로에서 유출되는 강우유출수와 비슷한 수준으로 유출되는 것으로 분석되었으나, 중금속의 경우 고속도로에 비해 고농도의 중금속이 유출되는 것으로 나타났는데, 이것은 차량 정차시 브레이크 패드나 타이어의 마모등에 의한 것으로 판단된다. 휴게소지점에 대한 면적당 발생되는 부하량 통계분석결과, TSS의 평균 부하량은 1411.6mg/m2로 산정되었으며, COD 709.7mg/m2, TN 44.0mg/m2, TP 10.4mg/m2로 산정되었다. 중금속의 경우 Total Cu 12927.4μg/m2, Total Fe 32074.4μg/m2, Total Pb 40371μg/m2, Total Ni 10679.2μg/m2로 산정되었다.