An intensive analysis was conducted of the maternal lineages of the Jeju native pigs (JNPs). A total of 100 mtDNA sequences from Asian wild boars (AWB), European wild boars (EWB), Asian domestic pigs (ADP), European domestic pigs (EDP), and JNPs were used for the phylogeny and network analyses. Two distinct JNP groups were found JNPA and JNPE in the Asian and European cluster. The maternal lineage of JNPE was the closest to that of EWB and a clear haplogroup sharing an identical haplotype (hap16) among 15 individuals of JNPE and 2 individuals of EWB was identified. However, except for hap18, no EDP shared any identical haplotypes with JNPE, suggesting that no obvious maternal contribution of EDP has occurred in JNPE in recent years. The possible existence of an additional and unknown path of maternal lineage from EDP into JNPE could therefore be postulated, in addition to those from AWB and ADP into the JNPA groups. Thus, JNPE appeared to have a pure maternal lineage that had no recent contact with EDP, and both the JNPA groups and JNPE are pure Jeju native pigs.

As a replacement for activated carbon, biochar was synthesized and used for the adsorptive removal of formaldehyde and nitrogen oxide. Biochar was produced from the fast pyrolysis of the red marine macro alga, Pyropia tenera. The P. tenera char was then activated with steam, ammonia and KOH to alter its characteristics. The adsorption of formaldehyde, which is one of the main indoor air pollutants, onto the seaweed char was performed using 1-ppm formaldehyde and the char was activated using a range of methods. The char activated with both the KOH and ammonia treatments showed the highest adsorptive removal efficiency, followed by KOH-treated char, ammonia-treated char, steam-treated char, and non-activated char. The removal of 1000-ppm NO over untreated char, KOH-treated char, and activated carbon was also tested. While the untreated char exhibited little activity, the KOH-treated char removed 80% of the NO at 50°C, which was an even higher NO removal efficiency than that achieved by activated carbon.

Refuse-derived fuel (RDF) produced using municipal solid waste was pyrolyzed to produce RDF char. For the first time, the RDF char was used to remove aqueous copper, a representative heavy metal water pollutant. Activation of the RDF char using steam and KOH treatments was performed to change the specific surface area, pore volume, and the metal cation quantity of the char. N2 sorption, Inductively Coupled Plasma-Atomic Emission Spectrometer (ICP-AES), and Fourier transform infrared spectroscopy were used to characterize the char. The optimum pH for copper removal was shown to be 5.5, and the steam-treated char displayed the best copper removal capability. Ion exchange between copper ions and alkali/alkaline metal cations was the most important mechanism of copper removal by RDF char, followed by adsorption on functional groups existing on the char surface. The copper adsorption behavior was represented well by a pseudo-second-order kinetics model and the Langmuir isotherm. The maximum copper removal capacity was determined to be 38.17 mg/g, which is larger than those of other low-cost char adsorbents reported previously.

The techniques of IVM, IVF and IVC of canine oocytes may provide useful information for gamete salvage programs and the conservation of endangered canidae. This investigation has been made to determine the efficiency of in vitro maturation (IVM) as a basic experiment to study the development of canine oocytes after in vitro fertilization (IVF). The rate of oocytes developing to the MII stage was higher in the hormone treated group (10 IU/ml hCG+eCG, 14.7%, p<0.05) than in the control group (0 IU/ml hCG+eCG, 10.0%). The monospermy and pronuclear rates of canine oocytes were investigated after caffeine treatment on IVF. Canine oocytes were fertilized in the Fert‐TALP medium supplemented with 0, 10, 20 or 30 mM caffeine (Fert I, Fert II, Fert III or Fert IV, respectively). The highest pronuclear formation rate was obtained in the Fert I for 24 h IVF (6.7%, 6/89). Therefore, it is believed that unlike in other mammals, caffeine in canine IVF does not increase the efficiency of fertilization rate, and is not an important factor.

Nanopowders of titanium dioxide incorporating the transition metal element(s) were synthesized by flame synthesis method. Single element among Fe(III), Cr(III), and Zn(II) was doped into the interior of crystal; bimetal doping of Fe and Zn was also made. The characteristics of transition-metal-doped nanopowders in the particle feature, crystallography and electronic structures were determined with various analytical tools. The chemical bond of Fe-O-Zn was confirmed to exist in the bimetal-doped nanopowders incorporating Fe-Zn. The transition element incorporated in the was attributed to affect both Ti 3d orbital and O 2p orbital by NEXAFS measurement. The bimetal-doped nanopowder showed light absorption over more wide wavelength range than the single-doped nanopowders

ZnO nanostructures with various shapes were synthesized under ambient pressure condition by a wet chemical reaction method. Nanorods of ZnO with hexagonal cross-section and their aggregates with radiate shape were synthesized. Precursor concentration affected considerably the shape evolution of ZnO nanorods. Low precursor concentration was proved to be more preferable to the growth of ZnO nanorods, which is attributed to the intrinsic characteristics of chemical reaction in the synthesis of ZnO from zinc compounds.

We report a carbothermal reduction process for massive synthesis of monolithic WO phase from tungsten oxide in the presence of carbon source. Carbon black powder was used as a carbon source and added to WO by 40 weight percent. Bundles of WO rods were formed over the temperature range of 80 to 90. Pure WO bundles could be separated from the mixture of WO and residual carbon black powder. Field emission character of WO phase was determined using the extracted WO rods. Flat lamp fabricated from the WO rods showed the turn-on field of 9.3 V/