PURPOSES : Fine dust significantly affects the atmospheric environment, and various measures have been implement to reduce it. The aim of this study is to reduce fine dust on roads by implementing porous pavements and a clean road system using the low-impact development technique. METHODS : We conducted quality tests (draindown, cantabro loss rate, tensile strength ratio, dynamic stability, and indoor permeability coefficient tests) and performance evaluation (dynamic modulus and Hamburg wheel-tracking tests) on the porous asphalt mixture. Subsequently, we constructed a porous pavement road in a test bed and conducted a permeability test. In the test bed, we installed a nozzle, a water tank, and a fluid pump to water the roadside. After the clean road system was completely installed, we measured the concentration of fine dust before and after water was sprayed. Additionally, we conducted a total suspended solids (TSS) test to confirm the reduction in re-suspended dust. RESULTS : All results from the quality test of the porous asphalt mixture satisfy the standards stipulated by the Ministry of Land, Infrastructure and Transport. Results from the dynamic modulus test show a low plastic deformation resistance but a high fatigue crack resistance. The results from the Hamburg wheel-tracking test satisfy the U.S. Department of Transportation standards. After the porous pavement was constructed, a permeability test was conducted, and the result satisfies the standard value. Using a particle counter, we measured the concentration of fine dust before and after water spraying, and results show 12.08% and 10.23% for PM10 and PM2.5 particles, respectively. The results from the TSS test show that after the initial water spray, almost all re-suspended dust are removed from a road. In unfavorable road conditions, almost all re-suspended dust are removed after a second water spray. CONCLUSIONS : The results of all of quality tests performed on a porous asphalt mixture satisfy the standards. By applying the results to a test bed, the problem of securing water is solved. Using the clean road system, 12.08% and 10.23% of PM10 and PM2.5 particles are removed, respectively. The system removes PM10 particles (larger particles) more effectively compared with PM2.5 particles. IN the future, we plan to revise the maintenance plan such that the porous pavement can exhibit long-term performance. Because pipe freezing may occur in the winter, we plan to analyze the periodic maintenance plan of the porous pavement and develop a solution to mitigate the issue of freezing pipes in the winter.

PURPOSES : The logistic roads for freight transport along to the new port of Busan have been suffered by the rapid weather changes including high temperature and torrential rain. As a result, the roads require annual repair, which have been distressed seriously by the heavy logistic and environmental loads. Therefore, we need to identify the cause of the road pavement distresses and find a proper design method to minimize the pavement distress in order to prohibit the problem aggravated. METHODS : The damaged conditions of the logistic roads were investigated on-site. In addition, applied pavement designs, real traffic volumes, and historical climatic information were intensively collected for this project. With the investigated and collected data Korean pavement design program (KPRP) was implemented to analyzed the causes of the damaged roads and conceive the pavement design draft optimized for the roads. RESULTS : According to the investigation and KPRP analysis, the traffic volume to transport freights impacts significantly the pavement distress, so that a higher PG grade binder type should be used, for which polymer modified asphalt (PMA) binders are recommended. Moreover, its pavement thickness should be increased to secure load bearing capacity, but thickening the pavement has been discouraged due to difficulties induced by the road-sectional change, especially road-height change. CONCLUSIONS : In conclusion, 5cm PMA overlay is suggested for the normal-scale maintenance, and 7cm PMA overlay for large-scale maintenance. Besides these, the application of Polymer-modified Stone Matrix Asphalt (PSMA) using PG76-22 binder would be the best preventive maintenance method, which has been well know as having higher fatigue resistant performance than general PMA. However, if we use PSMA, quality control should be very cautious since PSMA can be very susceptible premature distress if its production and construction are improperly proceeded.