Republic of Korea is preparing to decommission Kori Unit 1 and Wolsong Unit 1. Decommissioning of a nuclear power plant proceeds in the following stages: shutdown, transition period, decontamination, cutting, waste treatment, and site restoration. When nuclear power plant is decommissioned, It is expected that approximately 80,000 drums of radioactive waste will be generated per nuclear power plant. Therefore, various technologies are being researched and developed to reduce this to approximately 14,500 drums. Technologies for waste volume reduction are largely mechanical and electrical/thermal methods. Representative examples of mechanical volume reduction technologies include super compactors and electrical/thermal volume reduction technologies include induction and plasma torch furnaces. Both technologies are effective reduction technologies, but the reduction ratio varies depending on the type or condition of waste before treatment. For example, as a result of testing waste reduction using a super compactor at NUKEM in Germany, the reduction ratio was found to be between 1.3 and 7 depending on the type or condition of waste such as chips, ash, scrap metal, sand, etc. And according to IAEA-TECDOC-1527, when reducing the volume of metals, aluminum, lead, copper, brass, etc. using induction melting, the waste volume reduction ratio is 5 to 20. In this paper, referring to these results, a melting test was conducted using a previously developed plasma torch with an output of more than 100 kW. And volume reduction characteristics of this plasma torch was considered depending on waste type or condition.

Radioactive materials emitted from nuclear accident or decommissioning cause soil contamination over wide areas. In the event of such a wide area of contaminated soil, decontamination is inevitable for residents to reside and reuse as industrial land. There are many ways to decontaminate these contaminated soils, but in urgent situations, the soil washing, which has a short process period and relatively high decontamination efficiency, is considered the most suitable. However, the soil washing process of removing fine soil and cesium by using washing liquid as water and adding a flocculating agent (J-AF) generates slurry/sludge-type secondary waste (Cs-contaminated soil + flocculating agent). Since this form of sludge contaminants cannot be disposed, solidification is needed using an appropriate solidification agent to treat wastes for disposal. Therefore, this study devised a treatment method of contaminated fine soils occurring after the soil washing process. This investigation prepared the simulated wastes of contaminated fine soils generated after the soil washing, and pelletized the samples using a roll compactor under the optimum operating conditions. The optimum conditions of the device were determined in the pre-test. Roll speed, feeding rate, and hydraulic pressure were 1.5 rpm, 25 rpm, and 28.44 MPa, respectively. The waste forms were manufactured by incorporating created pellets (H 6.5 × W 9.4 mm) using polymers as solidification agents. Used polymers were main ingredient (YD-128), hardener (G-1034), and diluent (LGE). The optimum mixing ratio was YD-128 : G-1034 = 65 : 35 phr, and LGE was added in an amount of 10wt% of the total mixture. To confirm the disposal suitability of the manufactured waste forms, characterization evaluation was carried out (compressive strength, thermal cycling, immersion, and leaching test). Characterization evaluation revealed a minimum compressive strength of 23.1 MPa, far exceeding 3.44 MPa of the disposal facility waste acceptance criteria. Compressive strength increased to the highest value of 31.90 MPa after immersion test. To examine leaching characteristics, the pH, Electrical Conductivity (EC) and leachability index (􀜮􀯜) of leachates were identified. As results, pH and EC consistently increased or remained constant with leaching time. The average of Co, Cs and Sr nuclides was 17.76, 17.38 and 14.04, respectively, exceeding the value of 6 in the waste acceptance criteria. Effective waste treatment/ disposal can be achieved without increasing volumes of sludge/slurry by enhancing the technique of this research by performing additional studies in the future.