With the expansion of the shipping and port logistics industry in the 21st century, the traffic density is continuously increased because of the increase in volumes of world sea freight and fleets, as well as the increase in the causes of potential marine accidents, such as ship collisions and stranding. Accordingly, the International Maritime Organization (IMO) has requested that the installation and operation of VTS should be applied in areas with high risk of marine traffic, and the request should be included as one of the Safety of Life at Sea (SOLAS) regulations. In this paper, the fundamental requirements of the radar system for vessel traffic services were analyzed and the analyzing factors were based on the IALA guideline.s This paper also includes results for the requirement and recommendation analysis on detection distance, target separation, and the target position accuracy of X-band radar. Also, to check if it satisfies the requirement of detection distance, range and azimuth separation of small point targets, and target position accuracy from the IALA guidelines, the test was conducted through the radar image acquired at the VTS center, and hence, the validity of the technical performance requirements was confirmed.

Radar sensors are used for space situational awareness (SSA) to determine collision risk and detect re-entry of space objects. The capability of SSA radar system includes radar sensitivity such as the detectable radar cross-section as a function of range and tracking capability to indicate tracking time and measurement errors. The time duration of the target staying in a range cell is short; therefore, the signal-to-noise ratio cannot be improved through the pulse integration method used in pulse-Doppler signal processing. In this study, a method of improving the signal-to-noise ratio during range migration is presented. The improved detection performance from signal processing gains realized in this study can be used as a basis for comprehensively designing an SSA radar system.

The coaxial sample holder with 20mm in diameter and the adaptor from type N connector-to-20mmΦ coaxial tube are designed and manufactured which have been used for designing and measuring the fabricated microwave absorber. In addition, the measure in method of material constants of the microwave absorbers is described, which is focused on minimizing the error due to the sample's shapes, the fitting conditions, etc. After describing the design method of a single-layed microwave absorber, the microwave absorbers for X-band, C-band and S-band RADARs are designed and fabricated, respectively, which are composed of ferrite, carborn, and binder and have good performance. Futhermore, we develop the high performance microwave absorber in extremely wide-band type for RADAR, which is composed of different material and its mixing ratio and which could cover nearly from 4 to 10 GHz.