The aim of experimental evaluation is to investigate the effect of wear resistance on 3D printing FDM(Fused Deposition Modeling). For this purpose, ABS(Acrylonitrile Buadiene Styrene) material was applied to test of wear-resistance. Ball-on-disk wear test has been performed using steel balls to determine the variation of tribological characteristics. Friction coefficient, wear loss and friction force showed a difference in the respective test conditions.

Abstract
 기호설명
 1. 서론
 2. 본론
  2.1절 FDM 성형방식 및 재료
  2.2절 내마모 테스트 조건
 3. 실험 결과
  3.1절 표면 분석
  3.2절 경도테스트
  3.3절 내마모 분석
 4. 결론
 References

• 조숙진(Dept. of Automation Mechanical Engineering, VISION University, college of Jeonju) | Sook-Jin Cho Corresponding Author
• 설영일(Dept. of Automation Mechanical Engineering, VISION University, college of Jeonju) | Young-Il Sul