The development of this technology produced the design of welding mesh automation system and obtained the following results.
1. The performance criteria of this research and development were higher than this, resulting in more than 300 N/㎟ of disconnection and more than 250N/㎟ of double wire. Double wire also obtained values of as low as 521 N/㎟ and as high as 623 N/㎟
2. We compared the bending strength of the single mesh and the dual mesh by the bending test, and the result is 1692N of the average of single-mesh and 487N of double wire welded mesh.
3. As a result of the test, 64 minutes of abs of 5mm wire were 112 minutes of each. The welding speed was constant and stable.

ABSTRACT
1. 서 론
2. 기술개발 목표 및 기술내용
    2.1 기술개발 목표
    2.2 기술개발 내용
3. 시험방법 및 성능시험
    3.1 전단강도
    3.2 휨 강도 시험
    3.3 용접속도시험
    3.4 용접 불량률
    3.5 시험 방법 및 시험결과
4. 결 론
References

• 이원섭(School of Mechanical and Automotive Engineering, Gangneung-Wonju National University) | Won-Seub Lee Corresponding Author
• 한문석(Dept. of Software, Gangneung-Wonju National University) | Moon-Seog Han