A seal is one of the primary means of safeguards along with surveillance. The International Atomic Energy Agency (IAEA) uses various types of seals to verify the diversion of nuclear materials and is developing new seals according to the development of technology. Independent of the IAEA, ROK uses national safeguards seals for state-level regulation. A national safeguards inspector binds the nuclear material storage by combining a seal with a metal wire and checks the serial number of the RFID chip inserted in the seal with a reader. The Wolsong spent fuel dry storage facility has 14 modules, each with 24 seals, and thus a maximum of 336 national seals will be installed. Although dependent on the sealing method, it takes about 5 minutes to verify one seal. As such, a considerable workforce is required for verification, and both the IAEA and the ROK are currently conducting random inspections. In addition, there are cases where verification is impossible because old seals are damaged due to harsh environments and long exchange periods. Therefore, in this study, we analyzed cases in areas where sealing technology has been developed to improve the problems of the existing national safeguards seals. And we proposed a method for improving national seals by finding requirements of seals considering spent fuel dry storage facility characteristics. In international logistics, sealing is essential in product transport verification, terrorism prevention, and tariff imposition. Accordingly, the field of container sealing has been extensively developed, and the International Organization for Standardization (ISO) has regulated the mechanical requirements of the seal as ISO 17712 and the electronic requirements as ISO 18185. Mechanical seals include metal and plastic seals and metal seals include bolt seals, ball seals, and cable seals. In addition, there are various electronic seals, such as radio frequency identification (RFID), near field communication (NFC), infrared (IR). Recently, there has been a trend to use active seals that have a built-in battery and can implement various additional functions. Among the various seals, the main requirements for selecting seals suitable for dry storage facilities are as follows. First, use of a sealing tube longer than 10m should be possible. Second, it should have corrosion resistance so that it can be used for more than five years in the coastal area. Third, it must be a passive seal without a power supply. Fourth, it should not be overly costly. Finally, the seal verification time should be short. As a seal that satisfies these requirements, an electronic seal with application of the passive RFID method to the mechanical form of a metal cable seal is suitable. Since it is not an active seal, it is difficult to determine the time of breakage. Therefore, designing the seal such that the RFID is also damaged when the metal seal is broken will be helpful for verification. In this study, the requirements for national safeguards seals in dry storage facilities were defined, and measures to improve the existing national seals were studied. Field applicability will be evaluated through future sealing device design and demonstration tests.

• Sungho Yoon(Korea Institute of Nuclear Nonproliferation and Control (KINAC)) Corresponding author