Nuclear fuel assemblies are exposed to high temperature and high pressure environments underwater for long periods of time in a reactor, leading to deterioration of the assembly structure. These assembly consists of fuel rods, grids, a top nozzle, a bottom nozzle and guide tubes. In particular, the integrity of the guide tube made of Zircaloy-4 is a very important part in handling the assembly. In the Post Irradiation Examination Facility (PIEF), there are 14×14 Westinghouse STD assemblies that have lost their handleability due to the top nozzle being removed for damaged fuel rod test. To handle these assemblies, it is reasonable to use cut guide tubes whenever possible. Therefore, it is necessary to determine the irradiation embrittlement state of the guide tube before designing or manufacturing parts that can connect the top nozzle and the guide tubes. Therefore, in this paper, the location for installing the top nozzle-guide tube connection parts was selected in the height range of 3,460 to 3,713 mm, and guide tube specimens were made within that range. Offset strain was derived from the load-displacement curve obtained through compression testing to confirm whether the ductility of guide tubes was maintained. As a result, there was no significant difference in strength and ductility of the guide tube within the above length range. In addition, it was confirmed that the ductility was maintained enough to install the top nozzle-guide tube connection parts. Therefore, it is judged that there will be no problem even if the top nozzle-guide tube connection parts are installed in the guide tube to restore the handleability of the assemblies.

• SukWoo Hong(Korea Atomic Energy Research Institute (KAERI)) Corresponding author
• MyungChul Park(Korea Atomic Energy Research Institute (KAERI))
• SungGeun Kim(Korea Atomic Energy Research Institute (KAERI))