By providing an environment where energetic particles and micrometeorites can not penetrate, caves on Mars may serve as a human shelter in future Mars explorations. More than 1,000 cave entrance candidates have been detected; however, their physical characteristics that can be utilized in detecting more candidates have not been explored in detail. In this paper, we explore the nighttime temperature of 100 cave entrance candidates and their surrounding areas to investigate 1) the nighttime temperature tendencies relative to their surrounding areas and 2) the extent of these temperature differences. We find that 79% of the cave entrance candidates exhibit higher temperatures than the surrounding areas, and 59% show a temperature difference over 20K, suggesting that the cave entrances may generally show higher temperatures than the surrounding areas during the nighttime.

Irregular mare patches (IMPs), recently discovered on the Moon, are eruptions of magma on the lunar surface, and their origins are still in question. While prior studies on IMPs have mainly focused on optical image analysis, in this study, an analysis of the characteristics of minerals is performed exemplary for the first time. Modified Gaussian model (MGM) deconvolution was applied to the infrared spectrum to confirm the properties of the mafic mineral. Mafic minerals were analyzed for 6 olivine-rich (Ol-rich) IMPs out of 91 currently reported, and only 4 of them yielded results of significance. All four sites showed more abundance of Fe than Mg, and manifested a weak relationship with Mg-suite rock. However, a problem was discovered during the MGM application process due to pilot implementation. In order to solve this problem, it is required to adjust the MGM initial condition settings more precisely and to increase the signal to noise ratio of the observation data. Moreover, it is necessary to analyze the mineral properties for all IMPs considering minerals other than Ol and utilize them to deduce the origin of the IMPs.

Moon mineralogy mapper (M3)'s work proved that the moon is not completely dry but has some hydroxyl/water. M3’s data confirmed that the amount of hydroxyl on the lunar surface is inversely related to the measured signal brightness, suggesting the lunar surface is sensitive to temperature by solar insolation. We tested the effect of solar insolation on the local distribution of hydroxyl by using M3 data, and we found that most craters had more hydroxyl in shade areas than in sunlit areas. This means that the local distribution of hydroxyl is absolutely influenced by the amount of sunshine. We investigated the factors affecting differences in hydroxyl; we found that the higher the latitude, the larger the difference during daytime. We also measured the pyroxene content and found that pyroxene affects the amount of hydroxyl, but it does not affect the difference in hydroxyl between sunlit and shaded areas. Therefore, we confirmed that solar insolation plays a significant role in the local distribution of hydroxyl, regardless of surface composition.

At the suggestion of the NASA Meteoroid Environment Office (NASA/MEO), which promotes lunar impact monitoring worldwide during NASA’s Lunar Atmosphere and Dust Environment Explorer (LADEE) mission period (launched Sept. 2013), we set up a video observation system for lunar impact flashes using a 16-inch educational telescope at Chungnam National University. From Oct. 2013 through Apr. 2014, we recorded 80 hours of video observation of the unilluminated part of the crescent moon in the evening hours. We found a plausible candidate impact flash on Feb. 3, 2014 at selenographic longitude 2.1° and latitude 25.4°. The flash lasted for 0.2 s and the light curve was asymmetric with a slow decrease after a peak brightness of 8.7 ± 0.3 mag. Based on a star-like distribution of pixel brightness and asymmetric light curve, we conclude that the observed flash was due to a meteoroid impact on the lunar surface. Since unequivocal detection of an impact flash requires simultaneous observation from at least two sites, we strongly recommend that other institutes and universities in Korea set up similar inexpensive monitoring systems involving educational or amateur telescopes, and that they collaborate in the near future.

When humans explore the Moon, lunar caves will be an ideal base to provide a shelter from the hazards of radiation, meteorite impact, and extreme diurnal temperature differences. In order to ascertain the existence of caves on the Moon, it is best to visit the Moon in person. The Google Lunar X Prize(GLXP) competition started recently to attempt lunar exploration missions. Ones of those groups competing, plan to land on a pit of Lacus Mortis and determine the existence of a cave inside this pit. In this pit, there is a ramp from the entrance down to the inside of the pit, which enables a rover to approach the inner region of the pit. In this study, under the assumption of the existence of a cave in this pit, a 3D model was developed based on the optical image data. Since this model simulates the actual terrain, the rendering of the model agrees well with the image data. Furthermore, the 3D printing of this model will enable more rigorous investigations and also could be used to publicize lunar exploration missions with ease.

Lava caves could be useful as outposts for the human exploration of the Moon. Lava caves or lava tubes are formed when the external surface of the lava flows cools more quickly to make a hardened crust over subsurface lava flows. The lava flow eventually ceases and drains out of the tube, leaving an empty space. The frail part of the ceiling of lava tube could collapse to expose the entrance to the lava tubes which is called a pit crater. Several pit craters with the diameter of around 100 meters have been found by analyzing the data of SELENE and LRO lunar missions. It is hard to use these pit craters for outposts since these are too large in scale. In this study, small scale pit craters which are fit for outposts have been investigated using the NAC image data of LROC. Several topographic patterns which are believed to be lunar caves have been found and the similar pit craters of the Earth were compared and analyzed to identify caves. For this analysis, the image data of satellites and aerial photographs are collected and classified to construct a database. Several pit craters analogous to lunar pit craters were derived and a morphological pit crater model was generated using the 3D printer based on this database.