Concrete waste generated in the result of dismantling a concrete structure in a radiation control area and refractory brick waste generated from uranium pellet sintering furnace are surface-contaminated by uranium particle of which the enrichment is below 5%. These wastes are hard to decontaminate so it was necessary to develop the process for its disposal. So, we developed the Process Control Plan (PCP) for disposal of radioactive concrete waste describing a whole sequence of disposal and inspecting procedures based on the KNF Radioactive Waste Quality Assurance Plan (KN-WQAP) established in 2021. Based on the PCP, we crushed the concrete waste by jaw-crusher. Then we sieved the crushed concrete waste and removed the particle of which size is below 0.3 mm, using sieve-vibrator where the 0.3 mm mesh-sized sieve is installed inside. Before conducting the crush-sieving method based on the PCP, we conducted Process Control Assessment (PCA) based on the KN-WQAP. The purpose of the PCA is to check whether the output of the process satisfies the Acceptance Criteria of Korea Radioactive Waste Agency (KORAD) so that we could confirm the validity of the PCP. The evaluation item of the PCA is a particulate size verification test. The test is passed only if the component ratio of a particle size below 0.2 mm is less than 15% and the particle size below 0.01 mm is less than 1%. The very first 3 drums passed the test, so we began applying the PCP to whole target drums. In the process of conducting the crush-sieving method in earnest, qualified inspectors based on KNWQAP participated conducting sampling, measuring and checking whether a foreign material was included. They tested samples and packaged drums regarding 5 spheres of general, radiological, physical, chemical and biological characteristic. KNF disposed concrete and refractory brick waste by the crush-sieving method so that KNF could take over 100 drums to KORAD in 2021. But, it is needed to be improved that a dust size below 0.3 mm is generated as a secondary waste which needs to be solidified for the final disposal and the work environment is not good enough because of the dust.