Bis (2-ethylhexyl)phosphoric acid (HDEHP) is a renowned extractant, favored for its affinity to selectively remove uranium via its P=O groups. We previously synthesized HDEHP-functionalized mesoporous silica microspheres for solid-phase uranium adsorption. Herein, we investigated the kinetic and isothermal behavior of uranyl ion adsorption in mesoporous silica microspheres functionalized with phosphate groups. Adsorption experiments were conducted by equilibrating 20 mg of silica samples with 50 mL of uranium solutions, with concentrations ranging from 10 to 100 mgU L−1 for isotherms and 100 mgU L−1 for kinetics. Three distinct samples were prepared with varying HDEHP to TEOS molar ratios (x = 0.16 and 0.24) and underwent hydrothermal treatment at different temperatures, resulting in distinct textural properties. Contact times spanned from 1 to 120 hours. For x = 0.16 samples, it took around 50 and 11 hours to reach equilibrium for the hydrothermally treated samples at 343 K and 373 K, respectively. Adsorbed quantities were similar (99 and 101 mg g-1, respectively), indicating consistent functional group content. This suggests that the key factor influencing uranium adsorption kinetics is pore size of the silica. The sample treated at 373 K, with a larger pore size (22.7 nm) compared to 343 K (11.5 nm), experienced less steric hindrance, allowing uranium species to diffuse more easily through the mesopores. The data confirmed the excellent fit of pseudo-second-order kinetic model (R2 > 0.999) and closely matched the experimental value, suggesting that chemisorption governs the rate-controlling step. To gain further insights into uranium adsorption behavior, we conducted an adsorption isotherm analysis at various initial concentrations under a constant pH of 4. Both the Langmuir and Freundlich isotherm models were applied, with the Langmuir model providing a superior fit. The relatively high R2 value indicated its effectiveness in describing the adsorption process, suggesting homogenous sorbate adsorption on an energetically uniform adsorbent surface via a monolayer adsorption and constant adsorption site density, without any interaction between adsorbates on adjacent sites. Remarkably, differences in surface area did not significantly impact uranium removal efficiency. This observation strongly suggests that the adsorption capacity is primarily governed by the loading amount of HDEHP and the inner-sphere complexation with the phosphoryl group (O=P). Our silica composite exhibited an impressive adsorption capacity of 133 mg g-1, surpassing the results reported in the majority of other silica literature.

In this study, we evaluated the performance of phosphate-functionalized silica in adsorbing uranium and provided insights into optimizing the initial conditions of the uranium solution (concentration and pH), which are often overlooked in uranium adsorption studies. While most studies take into account the effect of pH on both the surface charge of the adsorbents and the dissolved speciation of uranium in solution, they often overlook the formation of solid phases such as β-UO2(OH)2 (cr) and UO3· 2H2O(cr), leading to an overestimation of the adsorption capacity. To address this issue, we considered the speciation of U(VI) calculated using thermodynamic data. Our findings suggest that it is reasonable to evaluate the adsorption performance at pH 4 and concentration below 1.35 mM. The formation of β-UO2(OH)2 (cr) starts at 23 μM (pH 5) and 1 μM (pH 6) and increases sharply with increasing concentration. To avoid interference from the formation of solid phases, experiments should be conducted at lower concentrations, which in turn require very small msorbent/Vsolution ratios. However, controlling small amounts of sorbent can be challenging, and increasing the volume of the solution can generate significant amounts of radioactive waste. We also used UV-vis spectra analysis to investigate the formation of solid phases. We found that a 100 mg L-1 uranium solution resulted in the formation of colloidal particles in the solid phase after 2.5 hours at pH 6, while at pH 4, no significant changes in absorbance were observed over 120 hours, indicating a stable ion phase. Based on these conditions, we obtained an excellent adsorption capacity of 110 mg g-1.