The purpose of this study is to research into which characteristic is shown according to a change in filler metal in case of CO2 gas arc welding by using Automobile Structural Steel(ATOS80). The major characteristics of this study were experimented by having Bevel angle as 50°, Root gap as 3mm, Filler metal as Solid wire & Flux wire, and the projected length of wire as 15mm. This study made the welded test specimens for the KS specification in advance suitably for the conditions, thereby having comparatively analyzed with the data value that was obtained through tensile test, hardness test, impact test and Macro Structure Detecting. Arranging the results that analyzed finally, the tensile strength and the hardness appeared to be excellent in case of welding with flux wire. The impact strength was indicated to be superior in case of welding with solid wire.

The study discusses remote control torch system that is equipped with CO2 double wire reel. The welding machine is 30m away from the wire feeder at the industrial site and the feeder is three to five meters away from the torch. Accordingly, the welders cannot control the current and voltage that meets the welding condition during work when they are working at a place that prevents them from seeing the control panel such as inside a vehicle or tank or at a far work site. They also have no choice but to stop working to change the wire reel when it is completely burned out. Such work suspension resulting from frequent moves to adjust current and voltage as well as replace the wire and subsequent cooling causes welding defects. The study produced a remote control torch equipped with double wire reel by simplifying and streamlining the existing CO2 functions to reduce the troubling issue. The remote control torch equipped with double wire reel and the existing CO2 /MAG welding torch were applied as V-groove butt in the vertical position using 9mm rolled steel for SM50A welding structure. After completion of welding, the condition of welded surface beads went through visual inspection as well as radiographic inspection to analyze the welding quality inside the welded part. The study also evaluated reduction of welding defects, cost saving, the replacing performance against the existing commercial welders and the effect on possible compatibility