Necessity of novel energy storage devices extensively increased due to consumption of high power in various devices. To address the issues, in this report, we are addressing with a composite Iron Sulfide/reduced Graphene Oxide ( Fe3S4/rGO) synthesized using the standard solvothermal method. X-ray diffraction and Field Emission Scanning Electron Microscope analysis results confirmed that Face-Centered cubic crystal structure of Fe3S4 and rGO’s surface is decorated with a mean diameter of < 50 nm Fe3S4 respectively. Transmission Electron Microscopy images show further evidence that dispersed Fe3S4 on the rGO surface. Fe3S4/ rGO exhibits specific capacitance of 560 F/g than its individual counterparts ( Fe3S4 = 200 F/g and rGO = 145 F/g) at 1 A/g of current density and maximum cyclic stability of 91% capacitance retention after 2000 cycles that may be the influence of synergy between the composite materials.

In this study, magnetite (Fe3O4) nanoparticles were electrochemically synthesized in an aqueous electrolyte at a given potential of -1.3 V for 180 s. Scanning electron microscopy revealed that dendrite-like Fe3O4 nanoparticles with a mean size of < 80 nm were electrodeposited on a glassy carbon electrode (GCE). The Fe3O4/GCE was utilized for sensing chloramphenicol (CAP) by cyclic voltammetry and square wave voltammetry. A reduction peak of CAP at the Fe3O4/GCE was observed at 0.62 V, whereas the uncoated GCE exhibited a very small response compared to that of the Fe3O4/GCE. The electrocatalytic ability of Fe3O4 was mainly attributed to the formation of Fe(VI) during the anodic scan, and its reduction to Fe(III) on the cathodic scan facilitated the sensing of CAP. The effects of pH and scan rate were measured to determine the optimum conditions at which the Fe3O4/GCE exhibited the highest sensitivity with a lower detection limit. The reduction current for CAP was proportional to its concentration under optimized conditions in a range of 0.09-47 μM with a correlation coefficient of 0.9919 and a limit of detection of 0.09 μM (S/N=3). Moreover, the fabricated sensor exhibited anti-interference ability towards 4-nitrophenol, thiamphenicol, and 4-nitrobenzamide. The developed electrochemical sensor is a cost effective, reliable, and straightforward approach for the electrochemical determination of CAP in real time applications.

The aim of this paper is to compare the characteristics of the T-P removal from synthesized municipal wastewater by electro-coagulation using cylindrical Al and Fe electrode as anode. For this purpose, a concentric circle type electrolysis reactor was used and the operating conditions for T-P removal from synthesized wastewater are as follows; potential 10 V, electrolyte 0.03% NaCl, initial T-P concentration 1.0 ~ 6.0 mg/L and flow rate 1.0 ~ 5.0 L/min. From the experimental results, T-P concentration of treated wastewater was decreased to less than 0.2 mg/L enough to discharge standard and Al electrode showed performance than Fe electrode for T-P removal by electro-coagulation. Optimal conditions for T-P removal to less than 0.15 mg/L which is 75% of discharge standard for large scale municipal wastewater plant (capacity higher than 500 m3/day) were obtained as follows; flow rate 2.503 L/min, and 2.337 L/min, HRT 1.059 min, 1.134 min, for Al and Fe electrode, respectively. Consumed mass of Al and Fe were of 3.76 times and 8.90 times respectively, were obtained to removed T-P at optimal conditions with potential 10 V, and 0.03% NaCl as electrolyte.