In this study, photocatalytic degradation of ammonia in petrochemical wastewater is investigated by solar light photocatalysis. Two-dimensional ultra-thin atomic layer structured MoS2 are synthesized via a simple hydrothermal method. We examine all prepared samples by means of physical techniques, such as SEM-EDX, HRTEM, FT-IR, BET, XRD, XPS, DRS and PL. And, we use fullerene modified MoS2 nanosheets to enhance the activity of photochemically generated oxygen (PGO) species. Surface area and pore volumes of the MoS2-fullerene samples significantly increase due to the existence of MoS2. And, PGO oxidation of MB, TBA and TMST, causing its concentration in aqueous solution to decrease, is confirmed by the results of PL. The generation of reactive oxygen species is detected through the oxidation reaction from 1,5-diphenyl carbazide (DPCI) to 1,5-diphenyl carbazone (DPCO). It is found that the photocurrent density and the PGO effect increase in the case with modified fullerene. The experimental results show that this heterogeneous catalyst has a degradation of 88.43% achieved through visible light irradiation. The product for the degradation of NH3 is identified as N2, but not NO2−or NO3−.

We report a simple procedure to fabricate single crystals 3D C60 having an FCC structure on silicon substrates using a vapour–solid set-up in vacuum conditions. The morphology of the deposited film can be tuned by controlling the temperature and position of the substrate. The as-fabricated samples are extensively characterised by transmission electron microscopy, scanning electron microscope, X-ray powder diffraction, Raman spectroscopy, X-ray photoelectron spectroscopy and nanoindentation, which allow us to shed light on the recrystallization process of the C60. In addition, the growth mechanism of the formation of crystalline 3D structure of the C60 film is discussed in detail. Based on the newly gained knowledge of mechanism and its unique properties, fullerene has shown huge potential as a solid lubricant on various kinds of substrates.

A novel fullerene derivative with photoresponsive azobenzene group was designed and synthesized, and its photoresponsive properties were reported. Starting from 4-nitrophenol, compound 1, which is containing fullerene moiety connected to azobenzene group through covalent linkage was synthesized by 5 steps. All the intermediates and the final compound were characterized by ¹H, 13C-NMR, FAB-Mass or elemental analysis. Compound 1 exhibited the expected photoresponsive behavior. Chloroform solution(10-5M) of it served to maximize the absorption at 351 nm corresponding to the trans-azobenzene chromophore. Irradiation of this solution with 365 nm light resulted in photoisomerization to cis-azobenzene, as evidenced by decrease in the absorbance at 351 nm and an increase in absorbance at 450nm. A hotostationary state was reached within about 150 s. Thermal reversion to the original spectrum was observed over the course of about 6 h at room temperature in the dark. However, exposure to bright sun light for about 5 s also effect almost complete reversion to the trans-isomer. This indicates that there is no strong steric influence on the trans-cis reversible isomerization of compound 1.

Boron doped fullerene C60 (B:C60) films were prepared by the thermal evaporation of C60 powder using argon plasma treatment. The morphology and structural characteristics of the thin films were investigated by scanning electron microscope (SEM), Fourier transform infra-red spectroscopy (FTIR) and x-ray photo electron spectroscopy (XPS). The electrochemical application of the boron doped fullerene film as a coating layer for silicon anodes in lithium ion batteries was also investigated. Cyclic voltammetry (CV) measurements were applied to the B:C60 coated silicon electrodes at a scan rate of 0.05 mVs-1. The CV results show that the B:C60 coating layer act as a passivation layer with respect to the insertion and extraction of lithium ions into the silicon film electrode.

This cycloaddition of [70]fullerene with methyl azidoacetate in benzene under ultrasonic irradiated condition afforded the closed [5,6]-bridged aziridino[70]fullerene derivative, which was unusual product of cycloaddition to the 5,6-junction of fullerene. Its structure was determined by FAB-MS, UV-vis, 1H- and 13C-NMR spectral data. The closed [5,6]-bridged aziridino[70]fullerene-functionalized gold nanoparticle films were self-assembled using the layer-by-layer method on the reactive of glass slides functionalized with 3-mercaptopropyl trimethoxysilane. The functionalized glass slides were alternately soaked in the solution containing closed the [5,6]-bridged aziridino[70]fullerene and 4-aminothiophenoxide/hexanethiolate-protected gold nanoparticles. The closed [5,6]-bridged aziridino[70]fullerene-functionalized gold nanoparticle films have grown up to 5 layers depending on the immersion time. The self-assembled nanoparticle multilayer films were characterized using UV-vis spectroscopy showed that the surface plasmon band of gold at 527 nm gradually became more evident as successive layers were added to the films.

분자들이 용액 내에서의 cluster나 박막 내에서의 cluster와 같이 다른 cluster로 뭉쳐졌을 때, 가시광선과 자외선부근의 영역에서 fullerene C60의 전자흡수 스펙트럼 변화가 관찰되었다. 2.73eV에서 흡수 피크들이 관찰되었는데, 이러한 피크들은 독립된 분자들로부터 온 것이 아니라 분자들의 직접적인 상호작용으로부터 온 것으로 생각된다. Grained fullerene 박막에서는 흡수피크들이 3.35eV에서도 관찰되었는데 이러한 피크들은 grain의 계면에서 분자들의 상호작용으로부터 온 것으로 생각된다. 이러한 흡수의 Dichroism은 비등방성 macrostructure를 갖는 시료에서도 관찰되었다.