In this study, We designated the injection molded plug housing for charging electric vehicles as a research subject. And we analyzed the effect of Rib design on the quality of injection molded products. First, we used the Taguchi method to derive optimal conditions for rib design. The factors were set as the Thickness of the rib, the Height of the rib, and the Radius of the rib. Each factor consisted of 5 levels and generated conditions for a total of 125. We performed an injection molding analysis and confirmed significant factors affecting the deformation of injection molded products through ANOVA. Based on this, the 25th design detail was selected as the optimal condition. In addition, We compared the results of the molding analysis with the molded products that did not design ribs. We confirmed that the molded product designed with ribs under optimal design detail improved the deformation amount by 22.22% and the residual stress by 8.35%, compared to the molded product not designed with ribs.

In this study, in order of to reflect the mold deformation in the injection molding process to design of mold, the mold deformation was analyzed by performing flow and structural analysis. The 5 inch LGP(light guide plate) mold, platen and tie bar were modeled and applied to the analysis. The result of melt pressure from flow analysis was extracted for use as boundary conditions acting on the mold surface in the structural analysis. In order to evaluate the accuracy of simulation analysis results, injection molding was performed under the process conditions of simulation. As a results, the mold deformation during injection molding tends to be similar that of injection pressure, and it is confirmed that it shows the behavior and properties of melt resins. Compared with the simulation and experiment, the error of the maximum mold deformation in the injection phase was 4.20%.

Smart phones are currently the most popular electronic devices with high volume production activities driven by high demand and requirements for rapid turnaround time. The changes of displacement were analyzed according to a variable of the gate size and runner system. The radial type and gate with large size were shown that better results in displacement. While the design and production of lenses, the key component of a camera, still need to be improved, the current technology has run into its limit with regard to trends in size and weight reduction. In this study, an injection molding analysis was performed on plastic lenses that are widely employed for smart phone cameras. Specifically, the displacement of lenses at the time of injection molding was studied by varying the gate size and runner system.

CAE technology is an integrated tool including all aspects such as powder, binder system, mixing, injection molding, debinding and sintering. Therefore, CAE technology is considered as one of core technologies for PIM industry in the future. Recently many researchers are developing not only CAE software itself but also application procedures of CAE software. In this study, the applications for CAE technology in PIM industry are presented including feedstock mixing effect, several cases of troubleshooting and optimization procedure.