검색결과

검색조건
좁혀보기
검색필터
결과 내 재검색

간행물

    분야

      발행연도

      -

        검색결과 2

        1.
        2021.06 KCI 등재 구독 인증기관 무료, 개인회원 유료
        In this study, we used a numerical analysis program to study the molding conditions that affect the flow rate at the time of injection, using a spiral mold, which is mainly used for the evaluation of the flow rate of plastic resin. The mold temperature, melt temperature, and flow rate are composed of experimental factors. The three plastic forming factors were divided into five to six levels each. Since then, changes in the flow rate temperature were analyzed as the level of each forming factor increased. Experiments showed that all three forming factors increased the filling length of the spiral mold and the temperature of the flow front by a total of 34.53°C, melt temperatures increased the temperature of the flow front by a total of 34.53°C, the temperature increased by the flow rate was 23.5°C, and the temperature increased by the mold temperature was 1.99°C. It was shown that the melt temperature was the largest, followed by the flow rate and mold temperature. It was also possible to check the effect of plastic forming factors on the speed of the flow front.
        4,000원
        2.
        2020.12 KCI 등재 구독 인증기관 무료, 개인회원 유료
        Plastic products molded by injection molding have become an essential element of our lives. In addition, plastics can replace parts that used to be metal in the past. Plastic molded products used as a part of a mechanical system require high precision. At the same time, the appearance quality of molded products is also an important evaluation factor. The appearance quality of a molded product is affected by injection molding conditions, plastic material fluidity, and the condition of the mold surface. In this study, the cause of the short shot of the dog house, which functions to assemble the plastic tailgate parts for automobiles, was analyzed. In order to solve the short shot problem of the dog house, the root thickness of the dog house, injection molding conditions, and fluidity of plastic materials were experimented. Through the injection molding experiment, it was found that when the dog house root thickness was increased from 0.8mm to 1.2mm, the filling amount of the doghouse part increased by 43% in experiment mold. These results were verified by injection molding analysis.
        4,000원