When dismantling a power plant, a large amount of radioactive tanks are generated, and it is estimated that a significant amount of sludge will accumulate inside the tanks during long-term operation. In the process of dismantling a radioactive tanks, it is important to know the composition of the sludge because the sludge present inside must first be removed and then disposed of. In the case of certain tanks, it can be predicted that corrosion products generated due to system corrosion are the main cause of sludge formation. However, in the case of some tanks, it is not easy to predict the sludge composition because various dispersed particles in addition to corrosion products may be mixed with the wastewater. Even if it is collected and analyzed, the sludge composition can change significantly depending on the operation history, so the analysis results cannot be considered representative of the composition. In the case of LHST, surfactant components introduced during the washing and shower process, oil components and dispersed particles dissolved by the surfactant accumulate inside the tank, making sludge difficult to remove. In addition, even if it is removed by ultra-high pressure spraying, unexpected problems may occur in the subsequent treatment process due to the surfactant contained therein. Therefore, it is necessary to analyze in more detail the characteristics of sludge accumulated in LHST and prepare countermeasures. A test procedure was prepared to evaluate the characteristics of sludge accumulating in LHST. According to the test results, the long-term sludge accumulation tendency of the LHST is summarized as follows. ① Initially, the sludge settling speed increases slowly until a surface sludge layer is formed. ② After the surface sludge layer is formed, the sludge rapidly settles until the sludge layer becomes somewhat thicker. ③ When the sludge layer is formed to a certain extent, the sludge escape rate increases and the sludge accumulation rate decreases again. It is assumed that the sludge escape speed is closely related to the fluid flow speed in the relevant area. It is believed that the combined effect of these phenomena will determine the thickness of the sludge layer that will accumulate inside the tank, but it was not possible to evaluate how much the sludge layer would accumulate based on the experimental results alone. However, it can be assumed that significant sludge accumulation occurred in areas where fluid flow was minimal and sludge formation nuclei easily accumulates.

The purpose of this study was to examine laundry behavior according to the number of households and the type of washing machine that each household used. The data was obtained from questionnaires filled out by 417 households, which included college students living in Seoul and Gyeonggi province. The results of this study are as follows: first, according to the results of survey about the number of household members and type of washing machine that household had, one or two-person households accounted for 24.0%. Regarding the type of washing machine that each household used, there were more drum washers. In households comprised of three or more persons, a higher percentage had a machine with a pulsator. Second, with regard to the method of classifying the wash in doing the laundry, all families classified the wash according to color and textile material. Third, with regard to the amount of detergent in doing the laundry, 63.5% of households used the recommended amount of detergent while 28.3% of households used more detergent than the recommended amount. Fourth, with regard to the set temperature of water in doing the laundry, 36.2% of households used cold water; this was the highest percentage. Fifth, with regard to input sequence in doing the laundry, most households put the wash in the machine in advance, and then filled the washer with water; 56.1% of households added a rinsing process for all washing processes.