The purpose of this study is to analyze the characteristics of hydraulic behavior of the natural channel flow according to the temporal classification mode, and thus propose the hydraulic analysis method for future channel design. For analysis, the temporal flow characteristics of the channel section was divided into the steady flow and the unsteady flow. For hydraulic analysis, the HEC-RAS model, which is a one-dimensional numerical analysis model, and the SMS-RAM2 model, which is a two-dimensional model, were used and the factors used for analysis of hydraulic characteristics were flood elevation and flow rate. The flow state was analyzed on the basis of the one-dimensional steady flow and unsteady flow for review. In the unsteady flow analysis the flow rate changed by (-)0.16%～(+)0.26%, and the flood elevation varied by (-)0.35%～(+)0.51% as compared to the values in the steady flow analysis. Given these results, in the one-dimensional flow analysis based on the unsteady flow the flood elevation and flow rate were greater than when the analysis was done on the basis of the steady flow. The flow state was analyzed on the basis of the two-dimensional steady flow and unsteady flow. In the unsteady flow analysis the flow rate varied by (-)0.16%~(+)1.08%, and the flood elevation changed by (-) 0.24%~(+)0.41% as compared to the values in the steady flow analysis. Given these analysis results, in the two dimensional flow analysis based on the unsteady flow, the flood elevation and flow rate were greater than when the analysis was done on the basis of the steady flow.

The purpose of this study is to analyze the sensitivity of the RMA2 model parameters reflecting the flow characteristics of stream junction and thus understand the hydraulic characteristics of the channel confluence flow. This study dealt with the input parameters of the RMA-2 model, a two-dimensional numerical analysis model widely used for researches both at home and abroad. The parameters of the RMA-2 model are roughness coefficient, turbulent diffusion coefficient, Coriolis forces latitude, Density, and mesh size. This study those parameters estimated from actual heavy rainfall, and varied the parameter size by (-)30%～+30% to review the characteristics of the flow characteristics of the channel section. Weobserved that when the ratio of the channel width was relatively small, the smaller the approaching angle was, the farther from the junctions became the generating place of the maximum flow velocity, however, when the ratio of the channel width was relatively large, the larger the approaching angle was, the farther the generating place of the maximum flow velocity from the junctions became. In particular, the distance between junctions and the place where the maximum flow velocity generated showed an absolute correlationover 90% of the relative channel width, but an inverse relationwas found when the distance to the place where the flow velocity generated was shortened as relative the channel width between the main channel and tributary increased.

In this study, we took the geometrical character of the river channel junction and hydrologic conditions as independent variables, and hydraulic behavior characteristics as an independent variable. The result, after multiple analysis was carried out, proved that, except for the generating area of the accelerating zone of velocity the accelerating zone and both the main channel and the tributary zone of stagnation the stagnation zone, there was correlation of over 90%. Also, derived presumed expression of the hydraulic characteristics of the junction was applied to the real natural channel - the river channel of the Guem-ho main channel (the A-yang bridge to the Guem-ho bridge). As the result, it proved that it represented hydraulic characteristics relatively well.

일반적으로 PSC 교량은 여러개의 강선을 포함하며, 이러한 강선들의 긴장순서에 따라 정착부의 파열력의 크기는 좌우된다. 그럼에도 불구하고 강선긴장순서에 대한 연구부족으로 강선긴장시 긴장순서를 설계자의 경험이나 직관에 의하여 결정하고 있다. 본 연구에서는 정착부의 파열력을 산정하는 여러 방법에 대하여 고찰한 후, 가장 합리적인 해석방법을 선택하여 PSC 교량중에서 가장 대표적인 PSC빔교와 PSC박스거더교에 대하여 해석을 통한 합리적인 긴장순서를 결정하였다. 본 연구에서 제시한 방법은 PSC교량 정착부의 파열력을 최소화하는 강선긴장순서 결정에 유용한 방법이 될 것이다.

본 논문에서는 수리모형 실험을 통하여 지류와 본류의 합류점의 접근각도, 본류의 유량 및 본류와 지류의 유량비 변화에 따른 합류부의 수리학적 특성을 파악하였다. 실험은 수로길이 450cm의 수로에서 실시하였으며, 본류와 지류의 수로폭은 각각 40cm와 32cm이었으며, 4조의 물탱크와 펌프가 설치되었다. 합류점 부근의 정체 구간의 길이는 접근각도가 증가함에 따라 증가되며, 본류의 유량과 지류와 본류와의 유량비가 증가되는 경우에도 이 경향은 동일하다. 그러

감조하천에서는 수위, 유량과 조석이 상호관련이 있다. 특히 저수위에서 조석의 영향을 감안하지 않은 수위-유량관계는 부정확하다. 본 논문에서는 수위와 조위의 수면차를 변수로 하여 감조하천에서의 유량을 계산할 수 있도록 하였다. 이를 위해 태화강 감조부에 위치한 울산수위관측소 지점의 저수위 유량을 수위 및 수위와 조위의 수면차로 나타내는 다중회귀식을 개발하였으며, 기존의 수위-유량곡선식과 비교한 결과 우수한 적용성을 확인하였다.

당근(Daucus carota L. cv. Hongshim)의 접합자배와 체세포배의 경정부의 구조는 주사전자현미경과 종단면 관찰을 통하여 이루어졌다. 접합자배의 경정부는 도립된 보우트형이고, 2ㆍ3ㆍ4자엽 체세포배의 경정부는 각각 도립된 보우트형, 피라미드형 및 볼록한 다이아몬드형으로 나타났다. 접합자배의 경정부는 다소 작은 세포들로 구성되어 있고, 초층과 내체의 구별이 된다. 체세포배의 경정부는 다소 큰 세포들이 불규칙하게 배열되어 있다.

In this paper, discontinuity parts in microstrip line with λ/4 open stub and one in crank type have been anlayzed by using FDTD(Finite-Difference Time-Domain) analysis method. The noise components, in this case, are occred at the discontinuites of the given microstrip lines, the complex poles were extracted by the analysis using GPOF (Generalized Pencil-of Function) method from electric field of time domain. It has, then, been found that the noise level and the noise frequency components included in signal could be derived.

The toxic effects of aluminium (Al) on growth, chlorophyll content, δ-aminolevulinic acid dehydratase (ALAD) activity and anatomy of root and shoot were investigated in 7-day-old azuki bean (Vigna angularis) seedlings. Significant depressions in root elongation was observed in the low concentrations of Al (50, 100 ㎛) and increasing Al concentrations caused a sharp decline of root and shoot growth. The degree of inhibition was dependent upon Al supply. Exposure to 50 ㎛ Al or more inhibited root elongation within 1 day. In the 50 ㎛ Al treatments, a recovery of root growth was seen after 7 days exposure. In contrast, lateral root initials was little affected by Al exposure. Al toxicity symptoms and growth responses were more well developed in the roots than in the shoots. Analysis of Al localization in root cells by hematoxylin staining showed that Al entered root apices and accumulated in the epidermal and cortical cells immeadiately below the epidermis. There was a good positive correlation between the level of chlorophyll and ALAD activity. Increasing Al concentrations caused a decrease in total chlorophyll contents, accompanied by proportional changes in ALAD activity, suggesting a coordinated reduction of a photosynthetic machinery. Al exerted specific influence on the morphology of root and shoot. At higher concentrations of Al the roots induced drastic anatomical changes. The epidermal cells were disorganized or destructed while the cortical cells exhibited distortion of cell shape and/or disintegration. The diameter of root and transectional area of cortical cells decreased considerably with Al treatment. In the shoot Al also enhanced reduction of diameter of shoot and cell size. Gross anatomy of leaves treated with Al did not differ significantly from the controls, except for fewer and smaller chloroplast. Our results indicate that toxic effect of Al appear to be manifested primarily in roots and secondarily on shoots, and changes in root morphology are related to changes in the root growth patterns. Results are further discussed in relation to the findings in other plant species, and it is concluded that Al causes morphological, structural and, presumably, functional damage to the roots of the species investigated.

벼의 엽색은 시비시기를 결정하는데 주요한 인자로써 가시부 영역에서 해석하고, 이들 엽색을 지배하는 광합성색소는 T.L.C.로 분리하여 검토하였다. 1. 벼의 엽색은 413, 432, 453nm(청색부)와 662nm(적색부)에서 흡광되였고, 그 중에서 최대흡광은 432, 662 nm 이었다. 2. 양흡광도비(청색부/적색부)는 벼 생태형간에는 근 차이는 없었으나. 비료간에는 비료양이 증가할수록 적었다. 3. 양흡광도비와 엽색도 및 엽록소함량과는 부의 유의상관이 인정되었다. 4. 광합성색소 조성비율은 출수기에서는 녹색계통색소, 출수후 30일에는 황색계통색소의 조성비율이 각각 컸다. 5. 벼 생태형별 광합성색소율 Chl. a의 조성비율은 출수기에는 다수계품종이 일반계품종보다 컸고, 출수후 30일에는 일반계품종이 다수계품종보다 컸으나, carotene는 그 반대이었다.