In this study, a comparative test operation was conducted through the alternate haul method to examine the selectivity of the four mesh sizes (60 mm, 90 mm, 110 mm, and 130 mm) of the trawl codend. The selectivity was analyzed using the SELECT model considering the fishing efficiency (split parameter) of each fishing gear in the comparative test fishing operation in the trawl and the maximum likelihood method for parameter estimation. A selectivity master curve was estimated for several mesh sizes using the extended-SELECT model. As a result of analyzing the selectivity for silver croaker based on the results of three times hauls for each experimental gear, it was found that the size of the fish caught increased as the size of the mesh size increased. When the selectivity for each mesh size analyzed by the SELECT model considering the split ratio was evaluated based on the size of the AIC value, the estimated split model was superior to the equal split model. Based on the master curve, the 50% selection length value was 2.893, which was estimated to be 136 mm based on the mesh size of 60 mm. In some selectivity models, there was a large deviance between observed and theoretical values due to the non-uniformity of the distribution of fished length classes. As a result, it is considered that appropriate sea trials and selectivity evaluation methods with high reliability should be applied to present trawl fishery resource management methods.