In order to measure an antifreezing tolerance, antifreeze proteins accumulated upon cold acclimation in apoplast were analyzed. As Dongborilho were cold-acclimated for 3 to 74 days there was an abrupt increase in apoplastic proteins up to 30 days and then decrease to the similar levels. Among the known antifreeze proteins, CLP produced in E. coli. and TLP purified from apoplast were used to generate antisera that allow to measure and localize the proteins in leaves of barley. The CLP of 27.7 kDa and TLPs of 6, 26, 27, 30, and 31 kDa were increased in their amounts in apoplast as cold treatment being longer. There was a correlation among the amounts of those proteins accumulated in apoplast and freezing tolerance as shown in field and ion leakage tests for five cultivars. The deposit of CLP was localized in the marginal area and the area adjacent to leaf vescular bundle cells in an increasing manner according to duration of cold acclimation but no variation was observed in terms of it's distribution. Based on the close correlation between levels of antifreeze proteins and degrees of freezing tolerance, the immunological methods was to develop to estimate a freezing tolerance in barley

Cyanidin 3-glucoside (C3G) content contained in the grains of blackish purple rice varieties, Heugjinjubyeo, Kilimheugmi, Heugnambyeo, Sanghaehy-anghyeolla, and the progenies derived from their crosses was evaluated by HPLC and UV-Vis spectroscopy. C3G content was higher in the range of 10-30% by using UV-Vis method compared to HPLC method. A significant linear relationship was, however, observed between two analytical methods. The correlation coefficient was 0.98. Thus, this results suggested that it would be able to use UV-Vis spectroscopy to determine C3G content which does not demanded precise value like selection.

IAEA, FT-04-020 및 ANS 16.1의 침출시험법을 각각 수행하여 얻은 시험결과를 이용하여 상호 비교 평가하였다. 붕산을 함유한 파라핀 및 시멘트 고화체에서의 Co 과 Cs의 ANS 16.1의 침출지수는 6이상이었으나 고화매질과 탈염수의 종류에 따라 상반되는 침출거동을 보였다. 침출수로 합성해수와 탈염수를 사용하였을 경우 Co는 시멘트 고화체에서는 합성해수, 파라핀 고화체에서는 탈염수에서 침출이 높았다. 반면에 Cs의 침출정도는 시멘트에서는 탈염수, 파라핀에서는 합성해수에서 높았다. Co의 침출분율은 시멘트 고화체에서 IAEA ＞ ANS ＞ FT의 순으로 높았으며, 반대로 파라핀고화체에서는 이의 역순이었다.

본 연구에서는 고온의 LiCl-LlO 용융염계에서 우라늄 산화물의 금속전환과 LiO의 전해반응이 동시에 진행되는 통합 반응 메카니즘을 기초로 한 전기화학적 금속전환기술을 제안하였다. 본 실험에서는 전기화학적 환원반응에 의해 생성된 Li 금속이온이 음극에 전착과 동시에 우라늄 산화물과 반응하여 금속전환율 99 % 이상의 우라늄 감속을 생성하는 통합 반응 메카니즘을 확인할 수 있었다. 또한 전기화학적 금속전환기술의 공정 적용성 평가 일환으로 우라늄 산화물의 금속전환성, 반응 메카니즘 규명, LiO의 closed recycle rate 및 물질전달 특성 등의 기초 데이터를 확보하였다 향후 전기화학적 금속전환기술은 LiCl-Li 용융염계의 금속전환공정의 반응조건 제한성 해소, 금속전환율 향상 및 공정의 단순화 등의 기술성과 경제성 향상 측면에서 획기적인 방안으로 고려될 수 있을 것으로 판단된다.

국내의 가동 중지된 우라늄 변환시설의 해체 시 우라늄 화합물로 오염되어 대량으로 발생될 금속폐기물의 재활용 또는 자체처분을 위한 제염기술로 전해제염 공정의 적용성을 평가하였다. 이를 위하여 우라늄 변환시설 내부설비의 주 구성 재료인 SUS-304 와 Inconel-600 금속시편을 대상으로 전해용해 실험을 수행하였다. SUS-304 와 Inconel-600 금속시편에 대한 전해용해 성능에 있어서 중성염 전해용액으로 SO가 가장 효과적이었으나, 우라늄변환시설의 가동 시 질산 매질과 주로 접촉했던 설비 표면의 이력과 시설 가동 중 발생한 우라늄 폐액의 성상을 고려하여 SO 전해용액 내에서의 SUS-304 시편에 대한 전해용해와 비교해서 약 30%, 그리고 Inconel-600 시편에 대해서는 거의 동등한 성능을 보인 NaNO 중성염 용액을 금속성폐기물의 전해제염 용액으로 선정하였다. 본 연구에서는 NaNO 중성염 전해용액에서 전류밀도, 전해시간 및 전해 용액의 농도가 SUS-304 및 Inconel-600 금속시편의 전해용해 성능에 미치는 영향을 조사하였다. 이 실험결과를 바탕으로 실제 우라늄 변환시설로부터 인출하여 , AUC 및 ADU 등의 우라늄 화합물로 오염된 시편에 대해 전류밀도 100mA/, IM NaNO 전해용액 내에서 전해 제염 실증시험을 수행하였으며, 오염물의 종류 및 오염준위의 대소와는 관계없이 모든 시편에 대하여 10분 이내의 짧은 시간 내에 자체처분 기준치 이하로 및 방사능 준위를 감소시킴으로써 본 중성염 전해제염이 매우 성공적임을 확인하였다.

The Carbon Bond Mechanism Ⅳ has been developed for use in urban- and regional-scale oxidant models. The photochemical mechanism, CBM4, contains extensive improvements to earlier carbon bond mechanisms in the chemical representations of aromatics, biogenic hydrocarbons, peroxyacetyl nitartes, and formaldehyde. Ozone is produced mainly by nitrogen oxides and hydrocarbon. By altering the initial concentrations of the mechanism, an analysis of the sensitivity of ozone concentrations to VOC/NOx ratios and VOC composition is conducted in this one-dimensional mechanism. Note that it is considered a chemical mechanism in order to understand the photochemical reactions within this mechanism. It analyzed the results of these simulations by applying a NOx-sensitive and a VOC-sensitive regime. These sensitivity regimes are changed to match the relative contribution of VOC and NOx concentrations to ozone production in simulations of two sets.

Korean medicinal plants were screened for their inhibitory activity against HIV-1 protease. The inhibitory activity of protease was determined by incubating the extracts in reaction mixtures containing protease and substrate His-Lys-Ala-Arg-Val-Leu-(p-NO2-Phe)-Glu-Ala-Nle-Ser-NH2 to perform proteolytic cleavage reactions. In this study the twenty six extracts from medicinal plants were investigated. Of the extracts tested, the extracts from the stem of Morus alba. exhibited the strongest activity with inhibition of 81% at a concentration of 100μg/ml. The extracts of the flower of Saxjfraga stolonifera, and stems of Euonymus japonica and Castanea crenata showed appreciable inhibitory activity (〉50%) against HIV-1 protease at same concentration.

To identify the new source of breeding materials for rice salt tolerance, the salinity tolerance of thirty-four varieties was evaluated under 0.5% saline condition at seedling stage. The salinity score showed highly significant correlations to dry weight and dead leaf ratio. The tested varieties were classified into three groups by visual score, reduction ratio of dry weight, and dead leaf ratio. Eighteen varieties were classified as the highly tolerant group (salinity scores of 1.3-3.7), seven varieties were fallen into the tolerant group (salinity scores of 4.2-5.8), and others were susceptible (salinity scores of 6.7-9.0). In highly tolerant group, most indica varieties including Getu, Dikwee and Kuatic Putic, didn't exsert a panicle under the Korean climate. But six varieties, Xiangcho V, Annapuruna, HP 3319-2wx-6-3-1, Giza 175, and GZ 2447-S-17, GZ 4255-6-3 were suitable to the Korean climate, and their heading date (6-16, August) and culm length (65-78㎝) were similar to the Korean varieties. Accordingly, these varieties can be utilized as crossing materials for the salt tolerance in japonica rice.

Genetic linkage maps serve the plant geneticist in a number of ways, from marker assisted selection in plant improvement to map-based cloning in molecular genetic research. Genetic map based upon DNA polymorphism is a powerful tool for the study of qualitative and quantitative traits in crops. The objective of this study was to develop genetic linkage map of soybean using the population derived from the cross of Korean soybean cultivar 'Kwangkyo, and wild accession 'IT182305'. Total 1,000 Operon random primers for RAPD marker, 49 combinations of primer for AFLP marker, and 100 Satt primers for SSR marker were used to screen parental polymorphism. Total 341 markers (242 RAPD, 83 AFLP, and 16 SSR markers) was segregated in 85 ~textrmF2 population. Forty two markers that shown significantly distorted segregation ratio (1:2:1 for codominant or 3:1 for domimant marker) were not used in mapping procedure. A linkage map was constructed by applying the computer program MAPMAKER/EXP 3.0 to the 299 marker data with LOD 4.0 and maximum distance 50 cM. 176 markers were found to be genetically linked and formed 25 linkage groups. Linkage map spanned 2,292.7 cM across all 25 linkage groups. The average linkage distance between pair of markers among all linkage groups was 13.0 cM. The number of markers per linkage group ranged from 2 to 55. The longest linkage group 3 spanned 967.4 cM with 55 makers. This map requires further saturation with more markers and agronomically important traits will be joined over it.