The green peach aphid(Myzus persicae) and sweet-potato whitefly(Bemisia tabaci) biotype Q are serious pests in hot pepper and cucumber. To optimize the formulation type of Clothianidin 1.8% granule, coated and extruded granule formulation types were tested against green peach aphid in hot pepper and sweetpotato whitefly in cucumber. Clothianidin 1.8% granules were incorporated in soil before transplant of hot pepper and cucumber. At recommend dose(540g ai/ha), the efficacy of Clothianidin 1.8% coated and extruded granules were 83.3% and 94.4% and continued until 50 days and 70 days against green peach aphid, respectively. Against sweet-potato whitefly, the efficacy of Clothianidin 1.8% coated and extruded granules were 65.7% and 96.3% at 32 days in cucumber, respectively. Clothianidin 1.8% extruded granule was safe on crops (hot pepper, cucumber, melon, cabbage etc.) at 540g ai/ha (recommend dose) and 1080g ai/ha. The results suggested that Clothianidin 1.8% extruded granule is promising as a best insecticide against green peach aphid and sweet-potato whitefly, because of the high efficacy and low phytotoxicity.

nanopowders with anatase structure were firstly prepared by controlling the pH value of a precursor solution without any heat-treatment at room temperature. The prepared nanopowders were hydrothermally treated in 10M NaOH solution at . Then, the samples were washed in DI water or 0.1M HCl. The nanotubes were characterized by X-ray diffraction (XRD), scanning electron microscope (SEM) and transmission electron microscope (TEM). The gas sensitivity of nanotubes for toluene gas was also investigated. The results show that nanotubes can be prepared by hydrothermal treatment. The morphology of nanotubes prepared by 0.1M HCl washing is destroyed to some extent. nanotubes with DI water washing show better sensitivity than that with 0.1M HCl washing.

Experimental measurements of flame shape and heat transfer characteristics were performed for impinged inverse diffusion flame(IDF) using propane as a fuel. The purpose of this study is to identify the favorable co-axial inverse diffusion flame structure for impingement heating. The flame consisted of an entrainment zone and mixing and combustion zone. The heat flux which represents heat transfer rate is measured by using a heat flux sensor that is located at the center of the impingement plate. The inverse diffusion flame structure has been classified into six modes. In these modes, several favorable flames for impingement heating were identified. In this study, the parameters are overall equivalent ratio(Φ), nozzle to impingement plate distance(h/d), vertical distance from the stagnation point and Reynolds number(Re) of combustion air.

The fuel test loop consisted an in-pile test section (IPS) and an out-pile system (OPS) is an nuclear fuel irradiation test facility installed in HANARO and its operating temperature and pressure are similar to those of commercial nuclear power plant’s. Penetration pipe connecting the IPS and OPS at the reactor concrete wall is supported by pool-wall pipe support. The existing pool-wall pipe support established in the HANARO have insulations even thought the leak tightness is not ensured. So, the need for an isolation of the insulations from the HANARO cooling water makes the existing pool-wall pipe support newly designed. In this study a structural evaluation for the pool-wall pipe support in accordance with the 2001 ASME B&PV Section III NF is implemented. The most critical primary and secondary stress intensities occur at the modified connection area of the main cooling water pipe and plate ring, but those values are less than the allowable stress. It is concluded that the existing pool-wall pipe support could be modified to a newly designed shape having an isolated insulation from a HANARO cooling water.