TMR 급여와 분리급여가 반추위 메탄발생량 변화에 미치는 효과를 연구한 사례가 많지 않다. 본 실험은 1일 실험사료를 체중의 1.8%(실험 1) 그리고 2.4%(실험 2) 수준에서 급여 하면서 triplicated 2×2 Latin square design을 이용하여 실험을 수행하였다. 각 실험에는 6마리의 Holstein steer를 이용하였고 2개의 군으로 나누어 각각 TMR 급여 또는 분리급여를 하였다. 공시 사료의 농후사료와 조사료 비율은 73% 그리고 27%이었다. 두 실험 모두 사료급여 방식 간의 1일 메탄발생량 차이가 없었다. 현재까지 보고된 국내 연구와 본 연구에서 얻어진 개체 별 1일 건물섭취량과 1일 메탄발생량과의 관계를 분석한 결과, 메탄발생량 (g/d) = 11.5 (±1.3) × 건물섭취량 (kg/d) + 14.2, R2 = 0.73, p<0.001의 회귀식을 유도하였다.

The present experiment was designed to investigate the effects of extruded linseed supplementation on methane production in Holstein steers. Four Holstein steers fitted with permanent cannulas were assigned to two dietary treatments in a duplicated 2 × 2 Latin square design: a control diet consisting of tall fescue straw (65%) and concentrate (35%), and a treatment diet supplemented with 3.8% extruded linseed by replacing a part of ingredients in the concentrate of the control diet. The concentrates of the control and the treatment diet were isoenergetic and isonitrogenous. Extruded linseed supplementation did not affect dry matter intake but significantly (P<0.05) increased the intake of lipid. Rumen pH was significantly (P<0.05) lower for control than for treatment. Although there was no significant difference between treatments, the concentration of total VFA in control was 21% higher than in treatment. The concentrations of acetic acid, propionic acid and butyric acid were not different between treatments. Extruded linseed supplementation significantly (P<0.05) reduced methane output(g/d) and emission factor. Methane conversion rate was lower for treatment than for control but no significant difference was found. The results of the present study showed that extruded linseed supplementation in the diet of Holstein steers could reduce methane output.

This study was conducted with two ruminally cannulated Holstein steers to examine the effect of micronized and steam flaked corn on ruminal fermentation characteristics. The in situ dry matter degradability after 48 h incubation was the highest (P<0.05) at micronized corn (2.5 mm thickness) compared with steam flaked corn treatments. The steam flacked corn (3.3 mm thickness) was degraded lower (P<0.05) than the 2.9 and 3.1 mm thickness of steam flacked corn. Effective dry matter degradability and the rate of constant were the highest (P<0.05) at micronized corn (2.5 mm thickness) compared with steam flaked corns as well. The in vitro dry matter degradability after 48 h incubation was tended to higher (P=0.088) at micronized corn (2.5 mm thickness) than steam flaked corns, whereas there is no significantly difference between steam flaked corn treatments. Total volatile fatty acid concentration was higher at steam flaked corn (2.9 mm thickness) than micronized corn (2.5 mm thickness) and steam flaked corn (3.1 and 3.3 mm thickness). The acetate : propionate ratio was the highest (P=0.008) at steam flaked corn (2.9 mm thickness) and the lowest (P=0.008) at micronized corn (2.5 mm thickness). Total gas and methane production after 48h ruminal incubation was the highest (P=0.001) at micronized corn (2.5 mm thickness) compared with steam flaked corns. According to these results, the thickness of steam flaked corn as resulted corn processing is believed to do not affect methane production. However, further study is needed to better understand the present results to verify the correlation between corn processing method and their thickness on methane production using the same thickness corns by difference processing methods.