Recent industrialization has led to a high demand for the use of fossil fuels. Therefore, the need for producing hydrogen and its utilization is essential for a sustainable society. For an eco-friendly future technology, photoelectrochemical water splitting using solar energy has proven promising amongst many other candidates. With this technique, semiconductors can be used as photocatalysts to generate electrons by light absorption, resulting in the reduction of hydrogen ions. The photocatalysts must be chemically stable, economically inexpensive and be able to utilize a wide range of light. From this perspective, cuprous oxide(Cu2O) is a promising p-type semiconductor because of its appropriate band gap. However, a major hindrance to the use of Cu2O is its instability at the potential in which hydrogen ion is reduced. In this study, gold is used as a bottom electrode during electrodeposition to obtain a preferential growth along the (111) plane of Cu2O while imperfections of the Cu2O thin films are removed. This study investigates the photoelectrochemical properties of Cu2O. However, severe photo-induced corrosion impedes the use of Cu2O as a photoelectrode. Two candidates, TiO2 and SnO2, are selected for the passivation layer on Cu2O by by considering the Pourbaix-diagram. TiO2 and SnO2 passivation layers are deposited by atomic layer deposition(ALD) and a sputtering process, respectively. The investigation of the photoelectrochemical properties confirmed that SnO2 is a good passivation layer for Cu2O.

Nickel oxide(NiO) thin films, nanorods, and carbon nanotube(CNT)/NiO core-shell nanorod structures are fabricated by sputtering Nickel at different deposition time on alumina substrates or single wall carbon nanotube templates followed by oxidation treatments at different temperatures, 400 and 700 oC. Structural analyses are carried out by scanning electron microscopy and x-ray diffraction. NiO thinfilm, nanorod and CNT/NiO core-shell nanorod structurals of the gas sensor structures are tested for detection of H2S gas. The NiO structures exhibit the highest response at 200 oC and high selectivity to H2S among other gases of NO, NH3, H2, CO, etc. The nanorod structures have a higher sensing performance than the thin films and carbon nanotube/NiO core-shell structures. The gold catalyst deposited on NiO nanorods further improve the sensing performance, particularly the recovery kinetics.

Lithium-ion batteries have been considered the most important devices to power mobile or small-sized devices due to their high energy density. LixCoO2 has been studied as a cathode material for the Li-ion battery. However, the limitation of its capacity impedes the development of high capacity cathode materials with Ni, Mn, etc. in them. The substitution of Mn and Ni for Co leads to the formation of solid solution phase LiNixMnyCo1-x-yO2 (NMC, both x and y < 1), which shows better battery performance than unsubstituted LiCoO2. However, despite a high discharge capacity in the Ni-rich compound (Ni > 0.8 in the metal site), poor cycle retention capability still remains to be overcome. In this study, aiming to improve the stability of the physical and chemical bonding, we investigate the stabilization effect of Ca in the Ni-rich layered compound Li(Ni0.83Co0.12Mn0.05)O2, and then Ca is added to the modified secondary particles to lower the degree of cationic mixing of the final particles. For the optimization of the final grains added with Ca, the Ca content (x = 0, 2.5, 5.0, 10.0 at.%) versus Li is analyzed.