The purpose of this study was to evaluate the method of estimating the areal precipitation reflecting the altitude of the mountainous terrain on Jeju Island by comparing and analyzing the areal precipitation using the Thiessen polygon method and the isohyetal method in mountainous streams. In terms of constructing the Thiessen polygon network, rainfall errors occurred in 94.5% and 45.8% of the Thiessen area ratio of the Jeju and Ara stations, respectively. This resulted in large areal precipitation and errors using the isohyetal method at altitudes below 600 m in the target watershed. In contrast, there were small errors in the highlands. Rainfall errors occurred in 18.91% of the Thiessen area ratio of Eorimok, 2.41% of Witseoreum, and 2.84% of Azalea Field because of the altitudinal influence of stations located in the highlands at altitudes above 600 m. Based on the areal precipitation estimation using the Thiessen polygon method, it was considered to be partially applicable to streams on Jeju Island depending on the altitude. However, the method is not suitable for mountainous streams such as the streams on Jeju Island because errors occur with altitude. Therefore, the isohyetal method is considered to be more suitable as it considers the locations of the rainfall stations and the orographic effect and because there are no errors with altitude.

Fiber-Reinforced Cementitious Composites (FRCCs)는 시멘트 복합체에 혼입한 전도성 섬유로 인해 전기 전도성을 가진다. 이러한 특성은 전기적 응답 계측을 통하여 별도의 센서 설치가 필요 없는 구조물의 균열 모니터링을 가능하게 한다. 하지만 전기적 응답은 균열 발생뿐 만 아니라 온도의 변화에도 민감하게 변화하기 때문에 온도 요인은 전기적 응답 계측을 통한 균열 탐지를 방해하는 요소로 작용할 수 있다. 더욱이 전기적 응답을 측정하기 위한 탐침의 개수가 증가 할수록 원하지 않은 접촉 노이즈가 발생하기 때문에 이 논문에서는 탐침의 개수를 줄이기 위해 자체적인 자가센싱 임피던스 회로를 설계하였다. FRCC의 균열 발생과 온도 변화가 임피던스에 미치는 영향성은 자가센싱 임피던스 회로를 이용해 실험적으로 측정되었으며, 실험 결과, 임피던스 응답은 균열 발생보다 온도 변화에 더 민감하게 변화됨을 알 수 있었다.

In this study, we calculated the fixed-type Areal Reduction Factor (ARF) of the Hancheon River basin in Jeju Island, and compared the calculated ARF and the ARF of the four major river basins suggested by the Ministry of Land, Infrastructure and Transport. As a result, the maximum fluctuation ratios of ARF for the four major river basins calculated using area, frequency, and initial duration time were significant: 7.61% for the Hangang River basin; 12.69% for the Nakdonggang River basin; 8.09% for the Kumgang River basin; and 17.98% for the Yeongsangang River basin. In addition, the differences between the maximum and minimum value of ARF for the Hancheon River basin based on 48 hours was 2.13%, and it was smaller than the one for the four major river basins: 8.92% for the Hangang River basin; 11.41% for the Nakdonggang River basin; 8.87% for the Kumgang River basin; and 17.17% for the Yeongsangang River basin. The Yeongsangang River basin had the highest difference.

This study reviewed the applicability of the existing flood discharge calculation method on Jeju Island Han Stream and compared this method with observation results by improving the mediating variables for the Han Stream. The results were as follows. First, when the rain-discharge status of the Han Stream was analyzed using the flood discharge calculation method of the existing design (2012), the result was smaller than the observed flood discharge and the flood hydrograph differed. The result of the flood discharge calculation corrected for the curve number based on the terrain gradient showed an improvement of 1.47 - 6.47% from the existing flood discharge, and flood discharge was improved by 4.39 - 16.67% after applying the new reached time. In addition, the sub-basin was set separately to calculate the flood discharge, which yielded an improvement of 9.92 - 32.96% from the existing method. In particular, the steepness and rainfall-discharge characteristics of Han Stream were considered in the reaching time, and the sub-basin was separated to calculate the flood discharge, which resulted in an error rate of –8.77 to 8.71%, showing a large improvement of 7.31 - 28.79% from the existing method. The flood hydrograph also showed a similar tendency.

In this study, the Chiu-2D velocity-flow rate distribution based on theoretical background of the entropy probability method was applied to actual ADCP measurement data of Gangjung Stream in Jeju from July 2011 to June 2015 to predict the parameter that take part in velocity distribution of the stream. In addition, surface velocity measured by SIV (Surface Image Velocimeter) was applied to the predicted parameter to calculate discharge. Calculated discharge was compared with observed discharge of ADCP observed during the same time to analyze propriety and applicability of depth of water velocity average conversion factor. To check applicability of the predicted stream parameter, surface velocity and discharge were calculated using SIV and compared with velocity and flow based on ADCP. Discharge calculated by applying velocity factor of SIV to the Chiu-2D velocity-flow rate distribution and discharge based on depth of water velocity average conversion factor of 0.85 were 0.7171 m3/sec and 0.5758 m3/sec, respectively. Their error rates compared to average ADCP discharge of 0.6664 m3/sec were respectively 7.63% and 13.64%. Discharge based on the Chiu-2D velocity-flow distribution showed lower error rate compared to discharge based on depth of water velocity average conversion factor of 0.85.