The electromagnetic interference(EMI) shielding sheet of grid pattern for the wireless charger has been designed by using grid pattern metal sheet, PET & DST stacking and laminating technology. For this purpose, the twisting protection and the bubbling prevention device, the automatic position adjustment controller, the visual sensors and the motor actuator for controller, the EMI shielding sheet cutting device and the main control system have been developed for manufacturing the apparatus. As the study result, the development on manufacturing the equipment and shielding sheet of the EMI shielding sheet of grid pattern for the wireless charger having the lamination productivity of 27.4m/min exceeded the target of 8m/min in this study. In addition, the magnetic induction and the applicable shielding sheet were prepared in the magnetic resonance system, all of the two wireless charging system. The power with a band of average 6.87MHz of shielding sheet was greater than the target of 30dB to 32.57dB. The available frequency with a band of average 7.95MHz the target was exceeded by a 7.00MHz.

The purpose of this study was to develop a grid forming equipment of the electromagenetic interference(EMI) shielding sheet for use in a wireless charger. In addition, the present study was to form a lattice in the surface of the thin metal ribbon to exert an electromagnetic wave shielding performance of the precision small electronic devices such as smart phones. For this, grid forming presses such as manual pressurized press, automatic pressurized press, heat pressurized press, and continuous grid forming equipment with cylinder roll type, and a grid inspection and grid uniformity inspection devices have been developed. Finally, the cylindrical roller-type continuous grid forming equipment showed the best suited.

This study is about the qualitative safety assessment for hydrogen gas filling facilities in Korea operating with one-bank type. The purpose of this safety assessment is about the development of components for design, fabrication, assembly, operability of dispenser and systems of the safety. For the qualitative safety assessment method, the study used FMEA(failure mode & effect analysis) and HAZOP(hazard & operability). This study evaluated the safety through FMEA and HAZOP then by referring to P&ID and PFD of hydrogen dispenser, thereby examining the dangerousness of the equipments, defects of the structure and problems of the operation.

Hybrid car can improve fuel efficiency using a power of motor that is generated during constant-speed or deceleration driving. The motor is located between engine and transmission. But, when voltage of main battery is low, fuel efficiency is low because the voltage can't run the motor. In this situation, this study observed fuel efficiency when using solar cell for assistance power. In order to verify a fuel consumption of hybrid car equipped solar cell for assistance power, the car was tested downtown driving. As hybrid car was equipped solar cell for assistance, fuel consumption was reduced 8.35 % at running air conditioner. And, at air conditioner doesn't work, fuel consumption was reduced 6.88 %. This point of view, CO2 is expected to reduce in similar proportion.