In this study, the effects of cryogenic treatment cycles on the residual stress and mechanical properties of 7075 aluminum alloy (Al7075) samples, in the form of a tube-shaped product with a diameter of 500 nm, were investigated. Samples were first subjected to solution treatment at 470˚C, followed by cryogenic treatment and aging treatment. The residual stress and mechanical properties of the samples were systematically characterized. Residual stress was measured with a cutting method using strain gauges attached on the surface of the samples; in addition, tensile strength and Vickers hardness tests were performed. The detailed microstructure of the samples was investigated by transmission electron microscopy. Results showed that samples with 85 % relief in residual stress and 8% increase in tensile strength were achieved after undergoing three cycles of cryogenic treatments; this is in contrast to the samples processed by conventional solution treatment and natural aging (T4). The major reasons for the smaller residual stress and relatively high tensile strength for the samples fabricated by cryogenic treatment are the formation of very small-sized precipitates and the relaxation of residual stress during the low temperature process in uphill quenching. In addition, samples subjected to three cycles of cryogenic treatment demonstrated much lower residual stress than, and similar tensile strength compared to, those samples subjected to one cycle of cryogenic treatment or artificial aging treatment.

This study is to investigate the ultimate strength and curling influence of single shear two bolted connection with 7075-T6 aluminum alloys. The validation of element analysis was verified through the comparison between test result and finite element analysis prediction and strength reduction rate by curling was estimated quantitatively. Moreover, additional parametric analysis with extended variables was conducted and the conditions of curling occurrence according to end distance and edge distance were proposed.

This study investigates the ultimate strength and curling influence in single shear bolted connection with 7075-T6 aluminum alloys using numerical approach. The applicability of finite element analysis was validated through the comparison between existing test results and numerical predictions. Curling was observed in some specimens with a relatively long end distance and reduced the ultimate strength of bolted connection. Strength reduction ratio by curling was estimated quantitatively and it is known that curling caused the strength reduction by maximum 21%.