This study is done as a comparison analysis on existing studies on analysis and interpretations of solenoids. When there is no power in a solenoid valve, a flow passage is formed from a pressurized ports, Pc, to Ps, which are connected to a crankcase of a pressurizer. An inlet to Pc port is varied in three different sizes: 3.8 ㎜(Type-1), 4.0 ㎜(Type-2) and 4.2 ㎜(Type-3). It is determined that there will be changes in coolant flow into the solenoid valve and the flow properties from Pc port to Ps port are compared and analyzed. As the results, the flow demonstrates the maximum speed of 500 ㎧, 46 ㎧ and 433 ㎧ with 0.2 ㎫ for the inflow pressure and the maximum speed of 1400 ㎧, 129 ㎧ and 1200 ㎧ with 1.5 ㎫ for the inflow pressure.

In this paper, we analyzed the characteristics of the mass flow rate and velocity of the refrigerant in response to a change in the number of holes and the diameter size(Type-1～4) of the valve guide refrigerant to flow from Pc to Ps when the pressure is constant. Type-1 is 40% higher mass flow flowing in the direction of Ps as compared with the Pc mass flow rate. Type-2 is 64% higher mass flow flowing in the direction of Ps as compared with the Pc mass flow rate. Type-3 is 50% higher mass flow flowing in the direction of Ps as compared with the Pc mass flow rate. Type-4 is 47% higher mass flow flowing in the direction of Ps as compared with the Pc mass flow rate.

This paper carried out a comparative analysis with papers on the analysis and analytic research of conventional solenoid. In case the current of solenoid valve is cut off, a flow path is formed from pressure port (Pc) connected with the crankcase of compressor to Ps port. At this time, the size of Pc port hole was so adjusted (Type-2) that it was smaller than 4.0mm(Type-1) of original hole by 0.2mm. After that, it was thought that an effect would be produced on the flow change of refrigerant which came into the solenoid vale, therefore the flow characteristics in moving from Pc port to Ps port was predicted and comparatively analyzed. According to the results of flow analysis, a velocity of approximately 46m/s and 129m/s was shown at the maximum in case of 0.2 and 1.5 MPa in Type-1, and the maximum velocity of approximately 500m/s and 1400m/s was shown in case of Type-2.

In this paper, the current of ECV block is connected to compressor crankcase on which the Pc port of Ps port Euro is formed(Type-1). Pc Port Internal Bellows are supposed to be affected by changes at the flow of refrigerant to the solenoid valve inside inhalation. There is Ps port at the direction of flow characteristic in predicting and analyzing. At suction pressures of 0.2MPa and 1.5MPa, maximum flow rates become 46m/s and 129m/s respectively. The refrigerant is discharged by compressor rotation around the axis of rotation from the inflow of port(Pd)(Type-2). By predicting and analyzing inlet flow, suction pressures become 2.7MPa and 3.6 MPa when maximum flow rates of 177.5m/s and 205m/s are affected on Pc ports of Euros with pressures of 1.2KPa and 3.8KPa respectively. This study result can be applied as the basic data for design of ECV.