Tetracycline is one of the most commonly used antibiotics in domestic and foreign livestock industries to suppress the growth of pathogens. Tetracycline has been reported as a non-biodegradable compound. Therefore it has been not completely removed in the sewage treatment process. In this study, tetracycline was degraded using liquid ferrate (VI). Based on these experiments, the optimal water condition (pH and water temperature) were selected, appropriate liquid ferrate (VI) dosage was calculated, and finally the degradation pathway was estimated with the intermediate products detected by LC/MS/MS. All degradation experiments were completed within 30 seconds and the optimal condition was obtained in basic condition (pH 10) at room temperature (20℃). And the appropriate molar ratio between tetracycline and liquid ferrate (VI) was 12.5:1. Finally, 12 intermediate products were detected with LC/MS/MS and the degradation pathways and the degradation pathways and proposed the degradation pathways.

This paper provided the information related to the removal of 2,4,6-tribromophenol using in-situ and stable liquid ferrates(VI). This research’s goal was to observe the differences of oxidation power between in-situ liquid ferrate(VI) and stable liquid ferrate(VI). The in-situ liquid ferrate(VI) (FeO4 2-) has been successfully produced with the concentration 42,000 ppm (Fe) after 11 minutes of reaction time. The stable liquid ferrate(VI) was also successfully produced following the modification method by Sharma with the produced concentrations 7,000 ppm. The stable liquid ferrate(VI) was stable for 44 days and slightly decreased afterwards. This research has been carried out using 2,4,6-tribromophenol as the representative compound. Both of ferrates(VI) have the highest oxidation capability at the neutral condition. Furthermore, the stable liquid ferrate(VI) has higher oxidation power than the in-situ liquid ferrate(VI).

The concern over the risk of environmental exposure to brominated phenols has been increased and has led the researchers to focus their attention on the study of bromophenol treatment. In this study, the effects of pH and ferrate(VI) dose on the degradation of 2-bromophenol were investigated. The results indicated that the oxidation of 2-bromophenol by liquid ferrate(VI) was found to be highly sensitive to the pH condition. Furthermore, the highest removal efficiency was observed at the neutral condition with the removal efficiency of 94.2%. In addition, experimental results showed that 2-bromophenol removal efficiency increased with increasing of ferrate dosage. Ferrate(VI) dose of 0.23 mM was sufficient to remove most of the 2-bromophenol with the efficiency of 99.73% and kapp value of 2982 M-1s-1. Seven compounds were identified as the intermediate products by the GC/MS analysis.