The changes in COD, TOC, T-P, and T-N concentrations were investigated for 2 years in the constructed wetland of Sookcheon, which was installed to improve the water quality of Daecheong reservoir in South Korea. In order to evaluate the pollution level of sediments in the wetland, settling velocity of particulate material (4 times) and sedimet material contents (6 times) were measured. COD and TOC concentrations increased slightly as they passed through wetlands, and T-N and T-P concentration tended to decrease. The material content (COD, T-P, T-N) of aquatic plants was higher in floating-leaved and free-floating macrophytes than emergent macrophytes. As a result of measuring the sedimentation rate of suspended materials, most of the suspended materials introduced into constructed wetlands were sedimented at a rapid rate in the first sedimentation site. In addition, sediment pollution of T-P and T-N in constructed wetland was in severe pollution. The sediments containing a large amount of T-P and T-N were eluted by physical and chemical environmental changes, which is likely to act as internal pollution sources in wetlands.

Vacuum kinetic spray(VKS) is a relatively advanced process for fabricating thin/thick and dense ceramic coatings via submicron-sized particle impact at room temperature. However, unfortunately, the particle velocity, which is an important value for investigating the deposition mechanism, has not been clarified yet. Thus, in this research, VKS average particle velocities were derived by numerical analysis method(CFD: computational fluid dynamics) connected with an experimental approach(SCM: slit cell method). When the process gas or powder particles are accelerated by a compressive force generated by gas pressure in kinetic spraying, a tensile force generated by the vacuum in the VKS system accelerates the process gas. As a result, the gas is able to reach supersonic speed even though only 0.6MPa gas pressure is used in VKS. In addition, small size powders can be accelerated up to supersonic velocity by means of the drag-force of the low pressure process gas flow. Furthermore, in this process, the increase of gas flow makes the drag-force stronger and gas distribution more homogenized in the pipe, by which the total particle average velocity becomes higher and the difference between max. and min. particle velocity decreases. Consequently, the control of particle size and gas flow rate are important factors in making the velocity of particles high enough for successful deposition in the VKS system.

Dynamic plastic deformation behavior of copper particles occurred during the cold spray processing was numerically analyzed using the finite element method. The study was to investigate the impact as well as the heat transfer phenomena, happened due to collision of the copper particle of in diameter with various initial velocities of into the copper matrix. Effective strain, temperature and their distribution were investigated for adiabatic strain and the accompanying adiabatic shear localization at the particle/substrate interface.