Hay-making is one of the most common way for forage preservation in livestock industry. The quality and production of hay could be affected by various factors. This experiment was conducted to investigate the effect of tedding time and frequency on drying rate and feed value of forage rye (Secale cereale L.) hay. Rye was harvested on heading stage using mower conditioner. Hay was tedded at each set hour(09:00, 13:00 and 17:00) and sampled at each set hour to determine dry matter (DM) content. After two months’ preservation, CP (crude protein), ADF (acid detergent fiber), NDF (neutral detergent fiber), IVDMD (in vitro dry matter digestibility), TDN (total digestible nutrient), RFV (relative feed value), DM loss, visual scores and total fungi count were determined for estimation of hay quality. Tedding was necessary for both speeding up drying rate and improving forage quality. Tedding at 17:00 showed lower NDF content (p<0.05), and also higher RFV value was found compared with tedding at 9:00 and 13:00 (p<0.05). On the other hand, it was observed that more DM losses would be found when tedding later (p<0.05). Tedding in 1~3 times per day were lower in ADF and NDF content (p<0.05), increased CP, TDN and RFV (p<0.05), got less DM loss (p<0.05), and contained less fungi during conservation compared with no tedding (p<0.05). On the other hand, tedding too frequent caused more DM loss (p<0.05). In conclusion, for shorter drying process and higher quality of forage rye hay, tedding at 13:00∼17:00 for 1∼2 times per day was recommended in this study.

In this study, to apply hydrogen energy to ship engine and to generate effective hydrogen production, we investigated the effects of high temperature H₂SO₄ feed rate and cooling water rate to pump parts with fixed frequency needed to reciprocate motion and a simulation was conducted at each condition. In the fixed frequency and cooling water inlet flow rate of 0.5 Hz and 3.9 kg/s, we changed the high temperature H₂SO₄ flow rate to 47.46 kg/s (it is 105 % of 45.2 kg/s), 49.72 kg/s (110 %), and 51.98 kg/s (115 %). Also, at 0.5 Hz and 45.2 kg/s of frequency and high temperature H₂SO₄ flow, the thermal hydraulic analysis was performed at the condition of 95 % (3.705 kg/s), 90 % (3.51 kg/s), and 85 % (3.315 kg/s). In overall simulation cases, the physical properties of materials are more influential to the temperature increase in the pump part rather than the changes on the feed rate of high temperature H₂SO₄ and cooling water. A continuous operation of pump was also capable even if the excess feed of high temperature H₂SO₄ of about 15 % or the less feed of cooling water of about 15 % were performed, respectively. When the increasing feed of high temperature H₂SO₄ of up to 5 %, 10 %, and 15 % were compared with base flow (45.2 kg/s), the deviation of time period rose to a certain temperature and ranged from 0 to 4.5 s in the same position (same material). In case of cooling water, the deviation of time period rose to a certain temperature and ranged from 0 to 5.9 s according to the decreasing feed changes of cooling water at 5 %, 10 %, and 15 % compared to a base flow (3.9 kg/s). Finally, the additional researches related to the two different materials (Teflon and STS for Pitch and End-plate), which are concerned about the effects of temperature changes to the parts contacting different materials, are needed, and we have a plan to conduct a follow-up study.