With the recent concern regarding cellulose enhancing radionuclide mobility upon its degradation to ISA, disposal of cellulosic wastes is being held off until the disposal safety is vindicated. Thus, a rational assessment should be conducted, applying an appropriate cellulose degradation model considering the disposal environment and cellulose degradation mechanisms. In this paper cellulose degradation mechanisms and the disposal environment are studied to propose the best-suitable cellulose degradation model for the domestic 1st phase repository. For the cellulose to readily degrade, the pH should be greater than 12.5. As in the case of SKB, 1BLA is excluded from the safety assessment because the pH of 1BLA remains below 12.5. Furthermore, despite cellulose degradation occurring, it does not always produce ISA. At low Ca2+ concentration, the ISA yield rate is around 25%, but at high Ca2+ concentration, the ISA yield rate increases up to 90%. Thus, for the cellulose to be a major concern, both pH and Ca2+ concentration conditions must be satisfied. To satisfy both conditions, the cement hydration must be in 2nd phase, when the porewater pH remains around 12.5 and a significant amount of Ca2+ ion is leaching out from the cement. However, according to the safety evaluation and domestic research, 2nd phase of cement hydration for silo concrete would achieve a pH of around 12.4, dissatisfying cellulose degradation condition like in 1BLA. Thus, cellulose degradation would be unlikely to occur in the domestic 1st phase repository. To derive waste acceptance criteria, a quantitative evaluation should be conducted, conservatively assuming cellulose is degraded. To conduct a safety evaluation, an appropriate degradation model should be applied to determine the degradation rate of cellulose. According to overseas research, despite the mid-chain scission being yet to be seen in the experiments, the degradation model considering mid-chain scission is applied, resulting in an almost 100% degradation rate. The model is selected because the repositories are backfilled with cement, achieving a pH greater than 13, so extensive degradation is reasonably conservative. However, under the domestic disposal condition, where cellulose degradation is unlikely to occur, applying such model would be excessively conservative. Thus, the peeling and stopping model derived by Van Loon and Haas, which suggests 10~25% degradation rate, is reasonably conservative. Based on this model, cellulose would not be a major concern in the domestic 1st phase repository. In the future, this study could be used as fundamental data for planning waste acceptance criteria.

지하 동굴식 처분장의 건설, 운영 및 중-저준위 방사성폐기물을 처분한 이후 발생하게 되는 오염물질(Rn, CH CO, HS, Radiolysis에 의한 방사능 가스 등)은 적절한 공기량을 필요로 한 곳에 정확히 분배시킬 수 있는 환기시스템에 의해 통제되도록 하여야한다. 특히 지하 처분장은 여러 개의 진입 터널, 저장 터널, 공기 유입-배기 터널, 수직갱 등으로 이루어진 복잡한 회로망의 형태로 나타나기 때문에 이에 적절한 기술적 접근이 필요하다. 본 논문에서는 이러한 환기시스템 구축을 위한 기술적 접근을 위해 미국의 WIPP (Waste Isolation Pilot Plant)처분장과 스웨덴의 SFR (Slutforvar for Reaktoravfall) 중-저준위 처분장을 모델로 하여 두 처분장의 소요환기량을 선정하고 설계상 통풍로의 단면적, 길이, 표면 거칠기 등을 고려한 환기회로를 구성하였으며, 수학적으로 계산되는 각 회로의 저항에 대해 기술하였다. 또한 이를 바탕으로 적절한 선풍기의 용량과 수직갱 운용방안을 설계하였다. 두 처분장의 지형상의 규모 및 환기시설 비교 결과, SFR 처분장에 비해 WIPP 처분장에서와 같이 병렬구조가 많을수록 처분장 전체의 저항이 감소되며 이러한 결과로 환기시스템의 운용비 절감효과를 얻을 수 있다는 결론을 얻었다. 따라서 처분용량 증대를 위한 대단면의 SFR 처분장 구조와 전체 저항 감소를 위한 WIPP 처분장의 병렬구조를 조합한 형태가 가장 합리적이며 효율적인 환기가 이루어질 수 있을 것으로 사료된다.