This study presents the thermal analyses of a spent fuel dry storage cask under normal and off-normal conditions. The environmental temperature is assumed to be 15 under the normal condition. The off-normal condition has an environmental temperature of 38 . An additional off-normal condition is considered as a partial blockage of the air inlet ducts. Two of the four air inlet ducts are assumed to be completely blocked. The significant thermal design feature of the storage cask is the air flow path used to remove the decay heat from the spent fuel. Natural circulation of the air inside the cask allows the concrete and fuel cladding temperatures to be maintained below the allowable values. The finite volume computational fluid dynamics code FLUENT was used for the thermal analysis. The maximum temperatures of the fuel rod and concrete overpack were lower than the allowable values under the normal and off-normal conditions.

Basic idea of Randall-Sundrum brane world model I and II is reviewed with detailed calculation. After introducing the brane world metric with exponential warp factor, metrics of Randall-Sundrum models are constructed. We explain how Randall-Sundrum model I with two branes makes the gauge hierarchy problem much milder, and derive Newtonian gravity in Randall-Sundrum model II with a single brane by considering small fluctuations.

In this paper, impregnated activated carbon fiber (IACF) was manufactured to pitch-based activated carbon fibers (ACF) with potassium hydroxide (KOH) by using wet impregnation method to raise nitrogen oxides (NOx) adsorptivity. The properties of IACF were observed using EPMA, TGA and DSC and NOx adsorptivity was observed at high and low temperature. Before and after adsorption was analyzed using ToF-SIMS for examine surface characterization of adsorbed NOx. The results showed that the better adsorptivity appeared for increasing KOH ratio. So, NOx adsorptivity showed result that is proportional between KOH and the adsorbed amount. On the other hand, adsorbent that manufactured without washing was better NOx adsorptivity than adsorbent that manufactured with washing. The behavior of adsorption show that crossing time of NO and NO2 delayed for a rising adsorptivity. And NO ratio increased but NO2 ratio decreased according as KOH ratio increases. NOx was confirmed through surface analysis that remain in NO2- and NO3- form on IACF surface.

The advanced method for CO2capture is currently one of the most important environmental issues in worldwide and it is therefore necessary to have available technologies, which minimize the discharge of CO2 including Carbon-14 from nuclear facilities into the atmosphere. A key aspect of this work is to provide the technically principal data required to improve a CO2 removal system for the utilization of regenerative sorbent use, specifically include suggestions regarding its modified column design (parallel dual-bed assembly), stop-restart operation and the economic feasibility of sorbent use. The removal performance of soda lime and the effects of relative humidity (RH) and packing bed-depth (BD) on CO2 removal were investigated. In a single-bed, it revealed that the utilization of soda lime for CO2 removal at line velocity of 13 cm/sec and bed depth of 12 cm increased with the increased relative humidity up to 85%. However, in the parallel dual-bed assembly applied with the stop-restart operation, a maximum utilization rate of soda lime for CO2 removal was obtained even at 55% of RH and 8 cm of BD, specifically the utilization rate of soda lime by using this CO2 removal assembly was about two-fold superior to that in a single-bed.